Superior DR500 manual Log Placement, Fire shown with optional Brick Liner Kit, DT, DR-600 Model

		Adjusting
		Set Screw
		Adjustment Rod
		Up (Fully Open
			Position)
Venturi
Air Shutter
Adjustment Rod Down
(minimum air
opening position)
	FACTORY AIR
	SHUTTER SETTING
		inches (mm)
Models		Applications	Applications
	Gas	using the	using the
D, DT
	Type	Appliance	Appliance
& DR
		Top Vent	Rear Vent
500	Nat.	3/32 (2.38)	3/32 (2.38)
	Prop.	1/8 (3.18)	3/8 (9.52)
600	Nat.	3/32 (2.38)	3/32 (2.38)
	Prop.	3/8 (9.52)	3/8 (9.52)
800	Nat.	3/16 (4.76)	3/16 (4.76)
	Prop.	1/2 (13)	1/2 (13)
Figure 6

Log Placement

WARNING: LOGS GET VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOGS ARE COOL. TURN OFF ALL ELECTRICITY TO THE APPLIANCE BEFORE YOU INSTALL GRATE AND LOGS.

WARNING: THIS APPLIANCE IS NOT MEANT TO BURN WOOD. ANY AT- TEMPT TO DO SO COULD CAUSE IR- REPARABLE DAMAGE TO YOUR APPLI- ANCE AND PROVE HAZARDOUS TO YOUR SAFETY.

WARNING: THE SIZE AND POSITION ON THE LOG SET WAS ENGINEERED TO GIVE YOUR APPLIANCE A SAFE, RELIABLE AND ATTRACTIVE FLAME PATTERN. ANY ATTEMPT TO USE A DIFFERENT LOG SET IN THE FIREPLACE WILL VOID THE WARRANTY AND WILL RESULT IN INCOMPLETE COMBUSTION, SOOTING, AND POOR FLAME QUALITY.

Carefully position the ceramic fiber logs and twigs over the burner as shown in Figure 7 (D, DR, DR-500), 8 (D, DT,DR-600) or 9 (D, DT, DR-800).For more detailed placement instructions, refer to the LOG PLACEMENT GUIDE accompanying this document.

Proper twig placement is critical to prevent sooting. Twigs should be placed in the gaps between the flame peaks and should be positioned so that at no time they impinge the flames.

(Fire shown with optional Brick Liner Kit)

Figure 7 D, DT, DR-500 MODEL

Figure 8 D, DT, DR-600 MODEL

(Fire shown with optional Brick Liner Kit)

Figure 9 D, DT, DR-800 MODEL

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 7