Trane XL Series manual Problem Solver, Extra Energy Tips, Insulation, Heating, Cooling

Page 6

The Problem Solver

Before you call for service, check the following:

Problem

Possible cause

Remedy

Insufficient heating

a. dirty filters

a. clean or replace

or cooling

b. air not circulating

b. check supply registers and

 

freely

return grills for blockage

 

c. blocked outdoor coil

c. clear away leaves or other

 

 

debris

 

 

 

Failure to operate

a. power off

a. make sure main switch is

 

 

in ON position

 

b. open circuit breaker

b. reset circuit breaker, or

 

or burned-out fuses

replace burned-out fuses

 

c. improperly adjusted

c. check setting, adjust

 

thermostat

thermostat

 

 

 

Blue auxiliary heat

When outdoor

Monitor light. If it stays on

light on

temperature falls,

continuously when above

 

intermittent lighting is

30°F, or if it comes on when

 

normal

50°F outdoors, call for service.

 

 

 

No Heating or

Blower door removed

Close door securely to

Cooling – Blower

or ajar

restore power to blower

does not operate

 

 

 

 

 

Unusual Noise

 

Call your local servicer

 

 

 

Reduce the burden of unexpected repair bills with a Trane Extended Warranty.

Trane offers the finest quality products and manufacturer’s warranties on the market. But, like all good things, the Trane- provided limited warranty on your new comfort equipment will come to an end. To keep you protected, Trane offers the Extended Warranty Program. It picks up right where your Trane limited warranty leaves off. And, it offers years and years of reliable protection at a low cost. Ask your dealer for program details.

The Trane Extended Warranty provides:

1.The opportunity to supplement your Limited Warranty for five or ten years.

2.Coverage that may include parts only or parts and labor for the duration of the agreement. Be certain you read the Extended Warranty for complete details and exclusions.

3.Service work performed by servicers knowledgeable of the operation of Trane equipment.

Extra Energy Tips

Insulation

1.Make sure your home is properly insulated. This is the single most important step in conserving energy. Thermal insulation should be specified in terms of thermal resistance (R-values). R-30 (10")

is recommended for ceilings, R-11 (3-1/2) for exterior walls and floors over unheated areas. In colder climates, consider additional insulation.

2.Infiltration of humid outside air is your heating and cooling system’s worst enemy — it could account for 15 to 30% of air conditioning energy requirements. Find the places where air can sneak into the home and plug them with caulking, weather- stripping or plastic. Also, weather- strip and caulk around all entrance doors and windows.

3.Cut heat transfer through your windows by 40 to 50% with double glazing (two panes of glass sepa- rated by a sealed air space) and low-e glass.

4.Use wood- or metal-frame storm windows even if single-glazed windows are high quality. The extra layer of glass and the layer

of still air will cut heat transfer considerably.

5.Install storm doors at all entrances to your house.

6.Keep all windows and doors closed.

7.Remember that by increasing the glass area, you increase the amount of heat added in summer and lost in winter.

8.Make sure fireplaces have tight- fitting dampers which can be closed when the fireplace is not in use.

9.Invest in a humidifier to conserve energy in winter. The air in your home won’t be as dry, so you stay comfortable at a lower temperature setting.

Heating

10.Locate the thermostat on an inside wall away from windows and doors.

11.Set the thermostat as low as comfort permits. Each degree over 68°F can add 3% to the amount of energy needed for heating.

12.People generate heat. So lower the thermostat a degree or two when expecting a large group of guests.

Cooling

13.Set the thermostat as high as comfort will permit.

14.Make sure attics are adequately ventilated to relieve heat buildup. If necessary, improve air flow by adding or enlarging vents.

15.When building a new house or renovating an old one, choose light-colored roof shingles to reflect more of the sun’s heat.

16.During moderate weather, don’t use the air conditioner unnecessarily.

17.Draw blinds or drapes to block the sunlight during the hottest part of the day.

18.Install awnings over windows exposed to direct sunlight.

19.In the cooling season, don’t run kitchen and bath exhaust fans longer than necessary.

20.Don’t place lamps, TV sets or other heat producing devices beneath a wall-mounted thermostat. Rising heat from the equipment may cause the heat pump to over cool your house.

5

22-5156-02-0403 (EN)

Image 6
Contents Use and Care XL Series Weathertron Heat PumpContents How it works to keep you comfortable Proper maintenance for maximum efficiencyHow to remove your filter It heats in winter It cools in summerImportant Service Information Service InformationProper maintenance How to operate your system for peak performanceInsulation Problem SolverExtra Energy Tips Heating

XL Series specifications

The Trane XL Series is a premium line of heating, ventilation, and air conditioning (HVAC) systems designed for energy efficiency, comfort, and reliability. Committed to delivering advanced technology and innovative features, this series is aimed at homeowners who seek optimal climate control in their living spaces.

One of the standout features of the Trane XL Series is its energy efficiency. Many models within the series are equipped with SEER (Seasonal Energy Efficiency Ratio) ratings that exceed the average, making them an environmentally friendly option that can significantly reduce energy bills. This is largely achieved through Trane's advanced cooling and heating technologies, such as variable-speed compressors that adapt to the home's temperature needs, providing precise comfort while minimizing energy consumption.

The use of Trane's proprietary high-efficiency Puron refrigerant enhances the eco-friendliness of the XL Series. This refrigerant is not only efficient but also environmentally safe, as it does not contribute to ozone depletion. Coupled with advanced coil designs that maximize heat exchange, the XL Series delivers superior performance, even in extreme weather conditions.

One notable technology integrated into the XL Series is the Communicating System. This smart technology allows different components of the HVAC system to work together seamlessly. The system monitors temperature, humidity, and air quality, making adjustments in real-time to ensure optimal comfort and efficiency. Homeowners can also enjoy the convenience of remote access and control through smart devices, allowing them to adjust their home’s climate from anywhere.

Durability and reliability are also key characteristics of the Trane XL Series. Built with high-quality materials, the systems are designed to withstand the test of time. Features such as the DuraTuff non-corrosive base pan and weather-resistant cabinet ensure longevity, while the comprehensive warranty options provide peace of mind to consumers.

The XL Series also incorporates advanced air filtration options that improve indoor air quality. These systems can be equipped with high-efficiency particulate air (HEPA) filters that capture allergens, dust, and other pollutants, creating a healthier living environment.

In summary, the Trane XL Series exemplifies cutting-edge HVAC technology, combining energy efficiency, smart home capability, and reliability. With the focus on delivering unparalleled comfort while also safeguarding the environment, the XL Series stands out as a leading choice for homeowners seeking effective climate control solutions.