Honeywell 4110XM manual Testing the System, Using Test Key

Page 26

Testing the System

Using the

5

TEST Key

The TEST key puts your system into Test mode, which allows each protection point to be checked for proper operation. Testing should be conducted weekly to ensure proper operation.

NO ALARM REPORTS WILL BE SENT TO THE CENTRAL MONITORING STATION while the system is in Test mode.

1.Disarm the system and close all protected windows, doors, etc. The keypad's READY message should be displayed and the READY indicator (if present) should be lit.

2.Enter your security code and press the TEST key.

3.The keypad will sound a single beep every 40 seconds as a reminder that the system is in the test mode.

Each time a protection zone is faulted, the external siren or bell should sound for one second and then turn off, while the keypad sounds 3 beeps. If this does not happen, call for service immediately.

4.Open and close each protected door and window in turn and listen for the required sounds. The identification of each faulted protection point should appear on the display.

5.Walk in front of any interior motion detectors (if used) and listen for the required sound as movement is detected. The identification of the detector should appear on the display when it is activated.

6.Follow the manufacturer's instructions to test all smoke detectors, to ensure that all are functioning properly. The identification of each detector should appear on the display when each is activated.

7.After all protection points have been checked and restored, there should be no zone identification numbers displayed. If a problem is experienced with any protection point (no confirming sounds, no display), CALL FOR SERVICE IMMEDIATELY.

8.Turn off the Test mode by entering the security code and pressing the OFF key.

– 26 –

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Ademco 4110XM About This Manual Proper Intrusion ProtectionTable of Contents Table of Contents General AlarmsSystem Overview KeypadsFire Protection Memory of AlarmSystem Overview cont’d Burglary ProtectionAbout the Keypad Keypad StylesAbout the Keypad cont’d Summary of System Status DisplaysKeypad Functions Summary of Keypad FunctionsKeypad Functions cont’d Emergency KeysQuick Arming Security CodesDuress Code Security Codes cont’d Assigning, Changing, or Deleting User CodesEntry/Exit Delays General InformationUsing Ready Key Checking for Open ZonesUsing Stay Key Arms Perimeter Only, Entry Delay On Arming the SystemUsing Instant Key Arms Perimeter Only, Entry Delay Off Arming the System cont’dUsing Away Key Arms Entire System, Entry Delay On Using Maximum Key Arms Entire System, Entry Delay OFF To Silence a Burglary Alarm Disarming and Silencing AlarmsUsing OFF Key To Disarm the SystemUsing Bypass Key Bypassing Protection ZonesBypassing Protection Zones cont’d Quick BypassUsing the Keyswitch ArmingChime Mode Using Chime KeyUsing Panic Keys Panic KeysPanic Keys cont’d Typical KeypadTesting the System Using Test KeyTrouble Conditions Check and Battery DisplaysPower Failure Trouble Conditions cont’d Other DisplaysCase Of Fire Alarm Fire Alarm SystemIf Installed Fire Alarm System cont’d Silencing Fire AlarmsDining Emergency Evacuation Function Procedure Comments Quick Guide to Basic System FunctionsSummary of Audible/Visual Notification Sound Cause DisplayProtection Zones List Owners Insurance Premium Credit Request Ademco 4110XMOwners Insurance Premium Credit RequestRegulatory Statements and Warnings FCC / IC StatementRegulatory Statements and Warnings cont’d TELEPHONE/MODEM InterfaceEvent of Telephone Operational Problems Limitations of this System Servicing Information TWO Year Limited Warranty Page Page Page Page ÊN5100V5BŠ
Top Page Image Contents