Honeywell 4110XM manual Event of Telephone Operational Problems

Page 40

IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS

If your security system has been connected to the telephone line, and there is trouble with regular telephone service, disconnect the security system from the telephone line by removing the plug from the RJ31X (CA38A in Canada) telephone wall jack (you should have been shown how to do this by your installing company). Do not attempt to disconnect the telephone line connection inside the control cabinet. Doing so will result in the COMPLETE disruption of your regular telephone service.

If the regular phone works correctly after the plug has been disconnected from the RJ31X wall jack, the security system has a problem and you should call your service representative for service immediately. If, upon disconnection of the security system from the wall jack, there is still a problem with telephone service, notify the telephone company that they have a problem and request prompt repair service.

IMPORTANT: A security system connected to an alarm monitoring station relies on that connection.

If the security system is at fault, reinsert the plug as soon as the security system is repaired.

If the phone service is at fault, re-insert the plug immediately, to ensure resumption of full protection upon restoration of phone service.

The user may not, under any circumstances (in or out of warranty), attempt any service or repairs to the system.

40

Image 40
Contents Ademco 4110XM About This Manual Proper Intrusion ProtectionTable of Contents Table of Contents Alarms System OverviewGeneral KeypadsMemory of Alarm System Overview cont’dFire Protection Burglary ProtectionAbout the Keypad Keypad StylesAbout the Keypad cont’d Summary of System Status DisplaysKeypad Functions Summary of Keypad FunctionsKeypad Functions cont’d Emergency KeysDuress Code Security CodesQuick Arming Security Codes cont’d Assigning, Changing, or Deleting User CodesEntry/Exit Delays General InformationUsing Ready Key Checking for Open ZonesUsing Stay Key Arms Perimeter Only, Entry Delay On Arming the SystemUsing Instant Key Arms Perimeter Only, Entry Delay Off Arming the System cont’dUsing Away Key Arms Entire System, Entry Delay On Using Maximum Key Arms Entire System, Entry Delay OFF Disarming and Silencing Alarms Using OFF KeyTo Silence a Burglary Alarm To Disarm the SystemUsing Bypass Key Bypassing Protection ZonesBypassing Protection Zones cont’d Quick BypassUsing the Keyswitch ArmingChime Mode Using Chime KeyUsing Panic Keys Panic KeysPanic Keys cont’d Typical KeypadTesting the System Using Test KeyPower Failure Check and Battery DisplaysTrouble Conditions Trouble Conditions cont’d Other DisplaysIf Installed Fire Alarm SystemCase Of Fire Alarm Fire Alarm System cont’d Silencing Fire AlarmsDining Emergency Evacuation Function Procedure Comments Quick Guide to Basic System FunctionsSummary of Audible/Visual Notification Sound Cause DisplayProtection Zones List Owners Insurance Premium Credit Request Ademco 4110XMOwners Insurance Premium Credit RequestRegulatory Statements and Warnings FCC / IC StatementRegulatory Statements and Warnings cont’d TELEPHONE/MODEM InterfaceEvent of Telephone Operational Problems Limitations of this System Servicing Information TWO Year Limited Warranty Page Page Page Page ÊN5100V5BŠ