Bosch Appliances D623, D625 manual Turn the System Part 2 On Cmd, Set Part 2 Points Cmd

D623 Series/D625 Series User's Guide Turn the System Part 2 On (Cmd 3)

4.During the last 10 sec. of Exit Delay, the keypad displays Do not exit! and emits a double tone every second to warn you not to exit and to turn the system off. The system turns Part On. The On indicator remains on steady.

Smiths Residence

Part On

5.To turn the system off, enter your passcode.

4.During the last 10 sec. of Exit Delay, the keypad displays Do not exit! and emits a double tone every second to warn you not to exit and to turn the system off. The system turns Part 2 On. The On indicator remains on steady.

Smiths Residence

Part 2 On

5.Enter your passcode to turn the system off.

Turn the System Part 2 On (Cmd 3)

Exit Delay Time (to be filled in by your security company).

You have __________ sec. to exit premises before

system turns on.

￿I can perform this command.

￿I cannot perform this command.

Part 2 On turns on the portion of your system designated as Part 2, leaving the rest of the system turned off. You can select the points that turn on for Part 2 On, whereas Part On points are determined by your security company (refer to Set Part 2 Points (Cmd

65)on page 12). Once you press [CMD] [3], the exit delay timer countdown begins.

Smiths Residence

Ok for Part On

In the following example, 60 sec, is used as the Exit Delay. Exit Delay is set by your security company and may vary from the example shown below.

1.Make sure that points are normal (not faulted).

2.Press [CMD] [3] to turn the system Part 2 On. The keypad may prompt you to enter a valid passcode.

3.Enter your passcode if necessary. The On indicator turns on. The keypad display scrolls the following:

60 seconds to Part 2 On.

To bypass points

Press Bypass.

For no delay

Press No Delay.

For All On press All On

48 seconds to Part 2 On.

Enter your passcode to stop the system from turning on during the exit delay. You can turn the system Part 2 On with No Delay by pressing [NO DELAY], or you may bypass points by pressing the [BYPASS] key.

Set Part 2 Points (Cmd 65)

￿I can perform this command.

￿I cannot perform this command.

Use this command to program which points are armed each time you turn the system Part 2 On. This lets you turn part of the system on to detect intrusion, while the remaining part of the system lets you move freely without sounding an alarm.

1.Make sure the system is turned off (On indicator is off).

2.Press [CMD] [6] [5]. The keypad may prompt you to enter a valid passcode.

3.Enter your passcode if necessary. The keypad display scrolls the following:

Pt2 Part 2 No

Front Door

Press 2* for

Pt2 Part 2 Yes

Pt3 Part 2 Yes

Hallway

Press 3* for

Pt3 Part 2 No

To exit

Press Cmd.

4.Enter the Point Number followed by the [*] key to toggle between Yes or No for Part 2 On. Repeat until all points are programmed Yes or No for Part 2 Mode (Yes = Active, ready to detect intrusion; No = Non-Active, you can move freely without sounding an alarm).

5.Press [CMD] to exit this command.

Turn the System On with No Delay

This command turns the system All On or Part On without entry or exit delays. Remember that turning the system on with no delay allows no exit or entry delay time through the designated delay point, like the Front Door.

1.Make sure all points are normal (not faulted).

12 Bosch Security Systems 9/04 46841E