Kicker KX2500.1 manual System Diagrams, Mono Channel Operation

Page 7

System Diagrams

The following diagrams shows the most common configurations for your Kicker KX2500.1 series amplifier.

MONO CHANNEL OPERATION

The KX2500.1 amplifier is capable of operating into a minimum impedance of 2 ohms (). If you are using a single voice coil woofer be sure the impedance of the voice coil is equal to or greater than 2. If using dual voice coil subwoofer or driving multiple subwoofers, be sure the net impedance presented to the amplifier is at least 2or greater.

REMOTE GROUND

TURN-ON

Installation

TO + 12 VOLT

KICKER

POWER SOURCE

300 A

FUSE

 

1/0 Gauge

18 Gauge

 

SIGNAL

1/0 Gauge

OUT

 

+

SIGNAL

IN

 

+

2

SUBWOOFER(s)

NOTE: For maximum performance from your Kicker KX2500.1 amplifier,

we recommend using Genuine Kicker Installation Accessories. Visit your local dealer or visit www.Kicker.com to learn more.

KX2500.1 Amplifier

7

Image 7
Contents Page KX2500.1 Remote Bass Level Control Dash or center console FeaturesRemove MountingWiring BIG AMP Ahead Mono Channel Operation System DiagramsTWO KX2500.1 Amplifiers & ONE DVC Subwoofer Coil Coil 1 +TWO Subwoofers ONE SubwooferFour Subwoofers Remote Bass Level Control Using the Signal Output Jacks PastCrossover Control NavigationBass Boost Green LED off, no output With a Volt Ohm Meter VOM check Trouble shootingPerformance RMS PowerWhat is not COVERED?