Kicker KX2500.1 manual Performance, RMS Power

Specifications

Performance

MODEL: KX2500.1

1500 x 1 @ 4 ohms, from 20-200 Hz, 14.4Vdc, 1% THD CEA-2006 (Watts)

Signal to Noise Ratio -46 CEA-2006 (ref: 1W, A-weighted)

RMS POWER

In Watts, All Channels Driven

@ 14.4Vdc, 4Ω Mono, 1.5% THD+N		1 x 1500
@	2Ω Mono, 1.5% THD+N	1 x 2500
@ 12.5Vdc, 4Ω Mono, 1.5% THD+N		1 x 1200
@	2Ω Mono, 1.5% THD+N	1 x 2000

Height:	2-1/2 inches / 6.35 centimeters
Width:	10-1/8 inches / 25.7 centimeters
Length with EndKaps:	30-9/16 inches (77.6cm)
Length without EndKaps:	26-5/16 inches (66.8cm)
Frequency Response:	20 Hz - 200Hz, +0, -1 dB
Input Sensitivity:	170 mV - 5 V low level, 340 mV - 10 V high level
Signal-to-Noise Ratio:	>85 dB, a-weighted, re: rated power
Electronic Crossover:	Variable low pass, 50 - 200 Hz, 12 dB/octave
KickBass Boost:	Variable 0 to +18 dB boost @ 40 Hz
Subsonic Filter:	12 dB/octave High Pass @ 25 Hz

Power Wire Chart

Kicker Recommended

For Maximum Performance

Amperage	Up to	5 to	10 to	15 to	20 to
Draw	5 ft.	10 ft.	15 ft.	20 ft.	25 ft.
0-20	8 Ga.	8 Ga.	8 Ga.	8 Ga.	4 Ga.
20-35	8 Ga.	8 Ga.	8 Ga.	4 Ga.	4 Ga.
35-50	8 Ga.	8 Ga.	4 Ga.	4 Ga.	4 Ga.
50-65	8 Ga.	4 Ga.	4 Ga.	4 Ga.	1/0 Ga.
65-85	4 Ga.	4 Ga.	4 Ga.	1/0 Ga.	1/0 Ga.
85-105	4 Ga.	4 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
105-125	4 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
125-150	1/0 Ga.	1/0Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
150-200	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
					x 2
200-250	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
				x 2	x 2
250-300	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.	1/0 Ga.
			x 2	x 2	x 2

*For current draw exceeding 300 amps or cable lengths in excess of 25 feet contact Kicker or your local Kicker dealer for advice.

	NOTE: All specifications and performance figures are subject to change. Please visit the support section at www.kicker.com for the most current information.
14	KX2500.1 Amplifier