Bosch Appliances DVA-12T installation manual 2Connection through an Ethernet Switches

Page 29

RAID Subsystem DVA-12T Installation ManualSubsystem Connection and Operation en 29

5.2.2Connection through an Ethernet Switches

In the configuration shown in Figure 5.2 all codecs and cameras are connected via an Ethernet Switch. This is a standard configuration for using IP cameras and codecs sharing the same iSCSI drive.

A maximum of 31 units can be connected. In this case, a unit is defined by having one (1) IP address, so e.g. a unit can be either a VIP X1, a Dinion IP camera or one VIP X1600 module.

Fig. 5.2 Connection through an Ethernet Switch

Bosch Security Systems

F.01U.027.798 V1 2006.06

Image 29

Contents

RAID Subsystem DVA-12T Page Table of Contents 01U.027.798 V1 Bosch Security Systems Precautions and Instructions Safety PrecautionsESD Precautions 3Certification01U.027.798 V1 Bosch Security Systems ISCSI Host Ports IntroductionProduct Overview Chassis Overview Enclosure ChassisRear Panel Overview 2Front Panel Overview3Hard Drive Numbering Front Handles Subsystem ComponentsBackplane Board RAID Controller Module Drive Trays6BBU 4Controller Module InterfacesDimm Module Cooling Modules Power Supply Units4Audible Alarms LED IndicatorsSubsystem Monitoring I2C busHot-swap Capabilities Hot-swappable ComponentsComponents Normalized AirflowInstallation Prerequisites Hardware InstallationPrecautions and Instructions IntroductionStatic-free Installation General Installation Procedure7Drive Tray Installation Rack/Cabinet InstallationInstallation Procedure Flowchart Installation Procedure DoneFront View of an Individual Drive Tray Drive Tray Key-lock Rotation Subsystem Monitoring Overview Subsystem MonitoringDrive Tray LEDs Status-indicating LEDsBrief Overview of the LEDs Name Color Status 3Controller Module LEDsEthernet Port LEDs PSU LEDs BBU Module LED 7Cooling Module LEDs Audible Alarm Default Threshold Values Failed Devices 4I2C MonitoringSubsystem Connection and Operation Channel Default Settings Model Host Channels Drive Channels1Cabling Host Connection TopologiesDirect-Attached, Single Connection 2Connection through an Ethernet Switches Power On Procedure Power OnPower On Enclosure Check List4Power On Status Check 4Power Off ProcedureMaintenance Subsystem Maintenance and UpgradingGeneral Notes on Component Replacement OverviewRemoving the Controller Module Controller Module Maintenance OverviewReplacing Controller Module Components 1DIMM Module Considerations 3DIMM Module ReplacementReplacing the Controller Module Push Back the Module Clips on the Sides of the Dimm Module Dimm Module Replacement Procedure2Procedure Replacing a Faulty BBU ModuleBBU Warnings and Precautions Replacing the PSU Module Replacing a Failed PSU ModulePSU Module Overview PSU Parts Identification 2Replacing a Cooling Module Cooling Module MaintenanceCooling Module Overview 7Replacing a Failed Hard Drive Hard Drive Maintenance Overview11 Front View of an Individual Drive Tray Replacing a Hard DriveInstall the new hard drive Technical Specifications SpecificationsSpecification Controller SpecificationsPower Supply Specifications Drive Tray SpecificationsCooling Module Specifications 6RAID ManagementNPC Fault Tolerance ManagementAccessories Spare Parts and AccessoriesSpare Parts Model Name DescriptionCOM1 Cable DB9 and Audio Jack Pin Outs Pin OutsEthernet Port Pin Outs CN1 Pin Number Pin NamePin Pin Name Main PowerPage Numerics IndexLAN XOR Page Page Bosch Security Systems