Guardian Technologies GGU350TT Handle Assembly, Vacuum Assembly upright Use contd Tool Assembly

Handle Assembly

Handle Assembly

•Insert handle in the handle inlet on the top of the body. (Fig. 6)

Handle Disassembly Handle

•Push the handle removal button.

•Pull handle upward to remove.

Protrustion to Lock

Handle Inlet

Handle

Removal

Button

Fig. 6

Vacuum Assembly: upright Use (contd)

Tool Assembly

tool assembly

•Attach crevice tool, dusting brush and upholstery brush into

storage area on the back of the vacuum. (Fig. 8)		Crevice
		Tool
	Fig. 8	Dusting
		Brush
		Upholstery
		Brush

Using in upright mode

using in upright mode

Push the Handle Release Pedal (Fig. 9)

•	Turn main power switch ON. Turn brush power switch ON.
•	CAUTION: The headlight and brush does not come on when in the upright
	position even if the switch is ON. You must release the handle for the brushroll

base assembly

Base Assembly

•Set the body on the top of the base. (Fig. 7)

•Use both sides of the guide feature on the base to align.

Base Disassembly

•Push the release canister pedal.

•Lift up and remove the body.

Base
Canister	Guides
Release Pedal

Fig. 7

to begin spinning. (Fig. 10)

	Base Safety
	Switch
	Base
	Handle Release
	Pedal
Fig. 9	Fig. 10

height adjustment knob

Height Adjustment knob

•Rotate the height adjustment knob to the correct carpet height. (Fig. 11)

•To clean bare floor, set this knob to the bare floor position and turn off the brush power switch. (Located on the top of the cleaner - see page 2)

Fig. 11

E-6 E-7