Guardian Technologies GGU350TT Upright Mode Tool Usage, Converting to canister mode, Tool usage

Upright Mode: Tool Usage

tool usage

1.Turn brush OFF.

2.Remove hose from base hose connector on the lower portion of the cleaner. (Fig. 12)

3.Remove handle from cleaner: Push handle removal button and pull up on handle to disconnect from body. (Fig. 13)

4.Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14)

5.Push button on wand to extend telescoping wand. (Fig. 15)

6. Select the tool needed for above-floor		cleaning and	attach to end of	wand.
		Hose	Handle Hose
			Connector	Handle
	Handle		Telescoping
			Button
				Hard Floor
	Handle		Handle	Nozzle
Hose
	Removal
	Button
Base Hose
Connector
Fig. 12	Fig. 13	Fig. 14		Fig. 15

converting to canister mode

converting to canister mode

1.Remove hose from base hose connector. (Fig. 16)

2.Step on Canister Release Pedal and pull body upward by canister handle. (Fig. 17)

3.Follow steps 3-5 in UPRIGHT MODE: TOOL USAGE section. (See above)

4.Insert end of handle into hard floor nozzle.

5.Canister mode.

Canister

Handle

Body

Hose

Canister Release

Base HosePedal

Connector

	Base
Fig. 16	Fig. 17

Important:

Storing in Upright mode

•After using the vacuum, store in upright mode.

•Store accessories on the storage clips located on the vacuum body.

•Wrap the cord around the cord storage hooks on the side of the body and hang the plug at the cord clip on the wand. (Fig. 18)

Cord Clip

Cord Plug

Fig. 18

	When returning to UPRIGHT mode hose MUST be removed
E-8	from handle and returned to inlet on body.	E-9