UV-C Light Bulb & Filter
Ultraviolet light technology, the same technology used in hospitals and commercial settings for sanitizing, is capable of eradicating mircoorganisms, mold spores and viral contaminants from the air.
It is recommended that you leave the Germ Guardian
To reorder bulb & filter pack EV9LB or EV9LBL, please call Customer Service 1.866.603.5900 or go to www.germguardian.com.
WARNING: Electrical Shock
under no circumstances should you clean the bulb, bulb holder or cylinder with water or wet solutions. This could cause electrical shock.
Use of the Germ Guardian Unit
When the Germ Guardian is turned on you will see two rings of blue light that let you know it is working. The Germ Guardian
Directions for Use
1.Plug unit into a 120V AC electrical outlet.
2.Switch the power button to the ON position.
A small red light should light up on the switch.
3. Use the knob next to the power switch to adjust the fan speed. Turn the knob clockwise for increased air flow.
4.For best results continuous operation
is recommended.
Note: the germ guardian unit contains no serviceable parts except its
Important Safety Instructions
WARNING: Electrical Shock
Always unplug the germ guardian unit from electrical outlet when servicing.
Replacing and Cleaning the UV-C Bulb & Filter
1.Turn off the unit and unplug it from
the electrical outlet.
2. Using a small phillips head screwdriver, loosen and remove the phillips screw located at the top of the unit, directly above the power cord.
3.Remove the top cap by lifting its side near the screw hole, then gently push the cap in the opposite direction.
4. As the cap loosens, you may lift it off.