First Alert FA1600C/CA/CB, fa1600c Federal Communications Commission FCC Part 15 Statement

Page 73

UL NOTICE: This is a “GRADE A” system.

“FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT”

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•If using an indoor antenna, have a quality outdoor antenna installed.

•Reorient the receiving antenna until interference is reduced or eliminated.

•Move the receiver away from the control/communicator.

•Move the antenna leads away from any wire runs to the control/communicator.

•Plug the control/communicator into a different outlet so that it and the receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.

The user or installer may find the following booklet prepared by the Federal Communications Commission helpful: “Interference Handbook”

This booklet is available from the U.S. Government Printing Office, Washington, DC 20402.

The user shall not make any changes Installation Instructions or User’s Manual. authority to operate the equipment.

or modifications to the equipment unless authorized by the Unauthorized changes or modifications could void the user’s

IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS

In the event of telephone operational problems, disconnect the control by removing the plug from the RJ31X (CA38A in Canada) telephone wall jack. We recommend that your certified installer demonstrate disconnecting the phones on installation of the system. Do not disconnect the phone connection inside the control/communicator. Doing so will result in the loss of your phone lines. If the regular phone works correctly after the control/communicator has been disconnected from the phone lines, the control/communicator has a problem and should be returned for repair. If upon disconnection of the control/communicator, there is still a problem on the line, notify the telephone company that they have a problem and request prompt repair service. The user may not under any circumstances (in or out of warranty) attempt any service or repairs to the system. It must be returned to the factory or an authorized service agency for all repairs.

– 73 –

Technical Manuals Online! - http://www.tech-man.com

Page 72 Page 74
Image 73
Page 72 Page 74
Contents $&&$&% Table of Contents Trouble Conditions General System OverviewPartitioned System Zones System Overview cont’dFire Protection Burglary ProtectionMemory of Alarm AlarmsSpeed Key Macros Device Timers Using SchedulesTo Access Another Partition Goto Command Phone Access & Voice Response Capability Self-Help FeatureMaster Keypad Operation To view the abbreviated instructionsSystem Overview cont’d Alpha Keypad About The KeypadsFunctions Of The Keypad Functions Of The Keypad cont’d Functions Of The Keypad cont’d General Information Entry/Exit DelaysDuress Code Security Codes & Authority LevelsQuick Arming Authority Levels Security Codes & Authority Levels cont’dTo view your authority level and system capabilities General Rules on Authority Levels and ChangesTo Add a User To Exit User Edit ModeRF Button ? To Change a Users Code Limited Use User#84 CommandTo Delete a User To Access Another Partition Accessing Other PartitionsGlobal Arming To Goto another partitionAccessing Other Partitions cont’d Fault 002 Loading Dock Window Common Lobby Operation Codes with Global Arming How User Codes Affect the Common LobbyCodes with Non-Global Arming Other Methods of Arming/Disarming To show faulted zones Using Ready KeyTypical fault display Checking For Open ZonesDisplaying All Zone Descriptors Bypassing Protection Zones Using Bypass KeyTo bypass zones, the system must be disarmed first Bypassing Protection Zones cont’d To use the Quick Bypass featureQuick Bypass Displaying Bypassed ZonesArming Perimeter Only Using the 3 Stay keyUsing the 7 Instant Key With Entry Delay OFFArming All Protection Using the 2 Away KeyUsing the 4 Maximum Key Using the 1 OFF Key Disarming And Silencing AlarmsTo disarm the system and silence burglary or fire alarms Arming Using The KeyswitchDisarming Using Key Chime ModeViewing Central Station Messages Panic Keys Using Panic KeysDefining Speed Key MacrosExecuting Speed Key Macros cont’dAccess Door Control To activate relays using a telephone and 4285 or 4286 VIP Using #70 Relay Menu ModeTo Exit Enter 00 NOW Using #70 Relay Menu Mode cont’dDelaying the Closing Time Using SchedulesTo delay the closing time Temporary Open/Close SchedulesProgramming Temporary Schedules Using Schedules cont’dTo program temporary schedules Using Schedules cont’d Days ? Mtwtfss HIT 0-7 X To enter the device timer menu mode Programming Device TimersProgramming Device Timers cont’d DAYS? Mtwtfss HIT 0-7 X Permanent ? To Display The Event Log Event Log ProceduresSelect the partition To Exit the Event Log Event Logging ProceduresUsing the 5 Test Key Testing The SystemTesting Your System Testing The System cont’dCase Of Fire Alarm Fire Alarm SystemSilencing a Fire Alarm Fire Display Lock Fire Alarm System cont’dFire Drill Test Code + # + Fire Alarm System cont’d Typical Trouble Displays Trouble ConditionsTrouble Conditions cont’d Call for Service ImmediatelyServicing Information Power FailureRecommendations For Smoke And Heat Detectors Recommendations For Proper ProtectionAddition, we recommend the following Recommendations For Proper Protection cont’dRecommendations For Proper Intrusion Protection Emergency Evacuation Maintaining Your System Replacing Batteries in Wireless SensorsTaking Care of Your System Maintaining Your System cont’d Silencing Low Battery Warning Tones at the KeypadRoutine Care Quick Guide To System Functions Function Procedure CommentsQuick Guide To System Functions cont’d Alpha Display Keypads Summary Of Audible NotificationGlossary Federal Communications Commission FCC Part 15 Statement Federal Communications Commission FCC Part 68 Notice Canadian Department of Communications DOC Statement Limitations of this Alarm System Limitations of this Alarm System Away IndexLsens ¬19¢Ll
Top Page Image Contents