Table 1: | to Combustibles | to | |
Back of | 0 (zero) | 0 (zero) | |
Heater | |||
|
| ||
Front of | 24 inches | 24 inches | |
Heater | (610 mm) | (610 mm) | |
Sides of | 6 inches | 1/8 inches | |
Heater | (152 mm) | (3.2 mm) | |
Floor/ | 12 inches | 2 inches | |
Ground | (305 mm) | (51 mm) |
The clearance for servicing is 24 inches in front of the water heater.
Attachment of the Water Heater
I°_° 0 o°°
wall installation
brackets
Electrical Connection
The water heater must be electrically grounded in accordance with local codes or in the absence of local codes with the most recent edition of the National Electrical Code, ANSI/NFPA 70. In Canada, all electrical wiring should be in accordance with local codes and the Canadian Electrical Code, CSA C22.1 Part 1. Do not rely on the gas or water piping to ground the water heater. A screw is provided in the junction box for the grounding connection.
The water heater requires 120 VAC, 60 Hz power from a properly grounded circuit.
A disconnect switch must be provided and installed for
the incoming 120 VAC power. It should be a type that is suitable for outdoor use. Check the National Electrical
Code, ANSI/NFPA 70 and your local codes for a proper
switch type to use in your area. The wiring diagram is located on the Technical Sheet attached to the inside of
the front cover.
Figure 2
1.Identify the installation location and confirm that the installation will meet all required clearances.
2.Securely attach the water heater to the wall using any of the holes in the wall installation brackets which are at the top and bottom of the water heater. Ensure that the attachment strength is sufficient to support the weight. Refer to the weight of the water heater in the Specifications section.
General Instructions
•A manual gas control valve must be placed in the gas
supply line to the water heater. A union can be used on the connection above the shut off valve for the future
servicing or disconnection of the unit.
•Check the type of gas and the gas inlet pressure before connecting the water heater. If the water heater is not of the gas type that the building is supplied with, DO NOT connect the water heater. Contact Sears for the proper unit to match the gas type.
•Check the gas supply pressure immediately upstream at a location provided by the gas company. Supplied gas pressure must be within the limits shown in the Specifications section.
•Before placing the appliance in operation all joints including the heater must be checked for gas tightness by means of leak detector solution, soap and water, or an equivalent nonflammable solution, as applicable.
(Since some leak test solutions, including soap and
PCB
i 120vAccoe,o22,RES..EcT
_liGROUN
SW{TCH
Figure 3
water, may cause corrosion or stress cracking, the piping shall be rinsed with water after testing, unless it has been determined that the leak test solution is non- corrosive.)
•Always use approved connectors to connect the unit
to the gas line. Always purge the gas line of any debris before connection to the water heater.
•The gas supply line shall be gas tight, sized, and so installed as to provide a supply of gas sufficient to meet the maximum demand of the heater and all other gas consuming appliances at the location without loss of pressure.
•Any compound used on the threaded joint of the gas piping shall be a type which resists the action of liquefied petroleum gas (propane / LPG).
•Refer to an approved pipe sizing chart if in doubt about the size of the gas line.
305 & 505 Outdoor Manual | 11 |