Kenmore 153.332419, 153.332463, 153.332363, 153.332319, 153.332161 Service and Adjustment contd

Page 21

Service and Adjustment (cont'd)

Draining

The water heater should be drained if being shut down during

freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.

Turn the gas control knob to the "OFF" position. CLOSE the cold water inlet valve to the water heater.

OPEN a nearby hot water faucet and leave open to allow for

draining.

Connect a hose to the drain valve and terminate to an

adequate drain.

OPEN the water heater drain valve to allow for tank draining. NOTE: If the water heater is going to he shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain.

Close thedrain valve.

Follow instructions in the "Filling The Water Heater" section.

Drain Valve Washer

Replacement

NOTE: For replacement, use a '_;' x '¥_" x X" thick washer available at your nearest hardware store. For ordering replace- ment washers, refer to the "Parts Order List" section.

Turn "OFF" gas supply to water heater. Follow "Draining" instructions.

Turning counter clockwise, remove the hex cap below the screw handle.

Remove the washer and put the new one in place.

Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.

Follow instructions in the "Filling The Water Heater" section.

Check for leaks.

Follow the lighting instructions in the "Lighting" section to restart the water heater.

Follow the lighting instructions in the "Lighting" section to restart the water heater.

Temperature-Pressure Relief

Valve Operation

The temperature-pressure relief valve must be manually operated at least once a year.

TEMPERATURE-PRESSURE

DISCHARGE PIPE

Failure to install and maintain a new properly listed tempera-

ture-pressure relief valve will release the manufacturer from any claim which might result from excessive temperature or pressure.

AWARNING

If the temperature-pressure relief valve on the appliance weepsor dischargesperiodically,this may be due to thermal expansion. Your water heater may have a check valve installed in the water line or a water meter with a check valve.Consultthe SearsService Center for further informa- tion. Do not plugthe temperature-pressurereliefvalve.

AWARNING

When checking the temperature-pressure relief valve opera- tion, make sure that (I) no one is in front of or around the outlet of the temperature-pressure relief valve discharge line, and (2) that the water manually discharged will not cause any property damage because the water may be extremely hot.

If after manually operating the valve, it fails to completely reset and continues to release water, immediately close the cold water inlet to the water heater, follow the draining

instructions, and replace the temperature-pressure relief valve with a new one.

_AP

ASSEMBLY

WASHER

Housekeeping

Vacuum around base of water heater for dust, dirt, and lint on a

regular basis.

AWARNING

INSTALLED IN SUITABLE AREA: To insure sufrmient venti-

lation and combustion air supply, proper clearances from the water heater must be maintained. See "Facts to Consider

About the Location" section. Combustible materials such as clothing, cleaning materials, or flammable liquids, etc. must

not be placed against or adjacent to the water heater which can cause a fire.

Service

Before calling for repair service, read the Start Up Conditions

and Operational Conditions found in the Troubleshooting Guide of this manual.

If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.

Contact SEARS Repair Services at 1-800-4-MY-HOME(1-800-469-4663).

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents For Your Safety AN Odorant is Added to the GAS Used by this Water HeaterWhat to do if YOU Smell GAS Awarning Safety PrecautionsSafety Precautions Acaution Contents Product Customer ResponsibilitiesMaterials Needed Materials and Basic Tools NeededRemoving the Old Water Heater Installation InstructionsAwarning AcautionFacts to Consider About Location Installation Instructions contdALL AIR ALL AIR from Inside BuildingsWater Piping Installation Completed Using Sears Installation KITRelief Valve Opening Temperature-Pressure Relief ValveFilling the Water Heater When the water heater is in useVent Pipe Installation Venting contdGas Piping Sediment Trap GAS Piping with Flexible ConnectorBefore Lighting the Pilot ContdOperating Instructions LightingCheck for Leaks Operating Instructions contd Whattodo if YousmellgasNot Force Water Temperature RegulationTank Sediment Cleaning Service and AdjustmentBurner Cleaning Venting System InspectionService and Adjustment contd Start Up Conditions SMOKE/ODORWater vapor Strange Sounds Smelly WaterAIR in HOT Water Faucets Little or no dissolved oxygen in the waterHigh Temperature Shut OFF System Troubleshooting Guide contdContd Not Enough or no HOT WaterLeakage Checkpoints 153.332161 39 Gal Parts Order List#38 Burner# Manual Improper venting Warranty

153.332319, 153.332363, 153.332419, 153.332111, 153.332161 specifications

Kenmore has established itself as a reputable brand in the realm of home appliances, and the model lineup including Kenmore 153.332319, 153.332111, 153.332463, 153.332419, and 153.332563 showcases a range of features designed for convenience and efficiency.

The Kenmore 153.332 series emphasizes energy efficiency, an essential factor in today’s eco-conscious world. These models are engineered to consume less electricity while maintaining optimal performance, reducing utility bills without compromising functionality.

One of the standout characteristics of these models is their advanced refrigeration technology. The multi-air flow system ensures even cooling throughout the refrigerator, preventing hotspots that can lead to spoilage. This feature is complemented by precise temperature controls, allowing users to adjust settings according to their storage needs, which is particularly beneficial for perishable goods.

In terms of storage, these models boast flexible shelving options. The tempered glass shelves are easily adjustable, catering to various sizes of food items and containers. The spacious door bins provide additional storage for condiments and beverages, enhancing organization and accessibility.

Another significant feature is the ice and water dispenser. Models like the 153.332463 and 153.332563 come equipped with advanced filtration systems that deliver clean drinking water and clear ice cubes. This feature not only adds convenience but also encourages healthier drinking habits.

The exterior design of these appliances is sleek and modern, often available in stainless steel finishes that complement any kitchen decor. The fingerprint-resistant coating minimizes smudges, allowing for easy maintenance and a pristine look.

Security and child safety are also key considerations in the design of these models. User-friendly locking mechanisms and alarm systems ensure that children cannot accidentally open the refrigerator, providing peace of mind for families.

The Kenmore series models feature high-quality construction and meticulous attention to detail. They are designed for long-lasting performance, backed by warranties that underscore the brand’s commitment to reliability.

In summary, Kenmore 153.332319, 153.332111, 153.332463, 153.332419, and 153.332563 are designed to meet the needs of modern households with their energy efficiency, advanced refrigeration technology, flexible storage options, convenience features, and robust design. These models exemplify Kenmore’s dedication to quality and user satisfaction, making them a valuable addition to any kitchen.
Top Page Image Contents