Kenmore 153.330402, 153.330502 Operating Instructions contd, Whatto Doif Yousmellgas, Not Force

Page 18

Operating Instructions (cont'd)

Lighting label on the water heater as it appears above the thermostat

FOR YOUR SAFETY READ BEFORE LIGHTINI

WARNING

If you do not follow these may resu t caus ng property

instructions exactly, a fire or explosion damage, personal injury or loss of life.

A.This appliancehas a pilot whichmust be lighted by hand.Whenlightingthe pilot,follow these instructions exactly.

B.BEFORELIGHTINGsmellall aroundthe appliancearea for gas. Be sure to smell next to the floor because

somegasis heavierthanair and willsettleon thefloor.

WHATTO DOIF YOUSMELLGAS

Do nottry to lightanyappliance.

Do not touch any electric switch; do not use any phonein yourbuilding.

Immediatelycall yourgas supplierfroma neighbor's phone.Followthegassupplier'sinstructions.

If you cannotreach your gas supplier,call the fire department.

C.Use onlyyourhandto pushin or turn the gas control knob.Neveruse tools.If the knobwill not pushin or turn byhand, don'ttry to repairit, call a qualifiedser- vice technician,Forceor attemptedrepairmay result in a fire or explosion,

D.Do not use this applianceif any part has been under water.Immediatelycall a qualifiedservicetechnician to inspectthe applianceandto replaceanypart of the

controlsystem and any gas controlwhichhas been underwater.

LIGHTING

INSTRUCTIONS

 

1.STOP!Readthe safetyinformationaboveon this label.

9. Push in control knob all the way and hold down.

2. Removeouterdoor.

 

Immediatelylight the pilot with a match.Continueto

3. Set the thermostat to lowest setting by turning the

hold controlknob in for about one (f) minuteafter

watertemperaturedial clockwise,(( _,)to its lowest

the pilot is lit. Releaseknoband it will pop backup.

temperaturesetting(witharrowon dial)as shown.DO

Pilot shouldremainlit. If it goes out, repeatsteps 3

NOT FORCE.

 

through8.

 

 

 

If knobdoesnot pop up when released,stop and

 

 

immediatelycall your service technicianor gas

 

 

supplier.

 

 

 

If the pilot will not stay lit after several tries,

4. Turngas controlknobclockwise_'V _ to "OFF" posi-

depressand turn the gas controlknobclockwise

_'_ to "OFF" and call yourservicetechnician

tion. Knob cannot be turned from "PILOT" to "OFF"

unlessknob is depressedslightly.DO NOT FORCE.

or gassupplier(Figure6,. page17)

(Figure6, page17)

 

10. Replace(or close) inner door.Replaceouterdoor if

5. Wait five (5) minutesto clear out any gas. If you then

door does not covergas controlon/off knobor tem-

smell gas, STOP!Follow"B" in the safety information

peratureadjustmentknob.(Figure9, page17)

aboveon this label. If you don'tsmell gas, go to the

11. At armslenqthaway,turn gascontro knobcounter-

nextstep.

 

clockwise_

to thefull "ON" position.Warning

6. Remove(or open) inner door located belowthe gas

do not use gas control knob to regulate gas

controlunit.

flow. (Figure8, page17)

 

7. Findpilot-followmetaltube THERMOCOUPLE I'l!,PILOTBURNER12. At arms length away,set the thermostatto desired

fromgascontrol.The pilot

_F__.,.

setting. The mark ( ) indicative of approximate

is locatedin front of the burner.

-

120°F is preferred starting point. Some local laws

 

 

8. If youdon'tsmellgas,turn knobon gascontrolcounter

may requirea lowerstarting point.If hotterwateris

desired,see instructionmanualand"warning" below.

 

 

clockwiseL,@ to "PILOT" position.(Figure7, page17)

13. Replacetheouterdoorif not replacedin step10.

WARNING

Hotterwater increasesthe risk of scald injury,Before changingtemperature settingsee instructionmanual.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest settingby turning the watertemperaturedial clockwise(F_) to its lowest

temperaturesetting(witharrowon dial)as shown.DO

NOT FORCE.

2. Turn gas control knob clockwise _t to "OFF"

position. Knob cannot be turned from "PILOT" to

"OFF" unless knob is depressedslightly. DO NOT

FORCE.

3. Replaceouterdoor(if removed).

]8

Image 18
Contents For Your Safety AN Odorant is Added to the GAS Used by this Water HeaterInjury Property DAM Safety Precautions AwarningSafety Precautions Safety Precautions onAwarning Contents Specifications Customer ResponsibilitiesTubing Cutters or Hacksaw Materials and Basic Tools NeededMaterials Needed Propane TorchInstallation Instructions Removing the Old Water HeaterInstallation Instructions contd Water Heaters Eventually Leak InstallationofFacts to Consider About Location Confined Spaces Installation Completed Using Sears Installation KIT Water PipingInstallation Instructions Filling the Water Heater VentingGas Piping GAS Piping with Sediment TrapGAS Piping with ALL Black Iron Pipe to GAS Control Installation Checklist Before Lighting the PilotCheck for Leaks Operating Instructions LightingII Warning Not Force Operating Instructions contdWhatto Doif Yousmellgas ForceTemperature Regulation Instructions ContdHotter Water can SCALDWater heatersareintendedto Burner Cleaning Service and AdjustmentTank Sediment Cleaning Burner InspectionDrain Valve Washer Replacement Service and Adjustment contdTemperature-Pressure Relief DrainingSMOKE/ODOR Expansion Tank Sizing ChartStart Up Conditions ThermalTroubleshooting Guide contd Strange SoundsAIR in HOT Water Faucets High Temperature Shut OFF System Water is TOO HOT Operational Conditions contdTroubleshooting Guide contd Leakage CheckpointsPower Miser TM 12 GAS Water Heaters Parts Order ListPower Miser TM 12 GAS Water Heaters Model Numbers Parts Order List contdWarranty MY-HOME