Service and Adjustment (cont'd)
Draining
The water heater should be drained if being shut down during
freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.
Turn the gas control knob to the "OFF" position. CLOSE the cold water inlet valve to the water heater.
OPEN a nearby hot water faucet and leave open to allow for
draining.
Connect a hose to the drain valve and terminate to an
adequate drain.
OPEN the water heater drain valve to allow for tank
draining.
NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate
to an adequate drain. Close the drain valve.
Follow instructions in the "Filling The Water Heater" section.
Follow the lighting instructions in the "Lighting" section to restart the water heater.
Temperature-Pressure Relief
Valve Operation
The
REL_VALVE
DISCHARGE PIPE
Failure to install and maintain a new properly listed tempera-
AWARNING
If the
expansion. Your water heater may have a check valve installed in the water line or a water meter with a check
valve. Consult the Sears Service Center for further informa-
tion. Do not plug the
AWARNING
When checking the
If after manually operating the valve, it falls to completely reset and continues to release water, immediately close the cold water inlet to the water heater, follow the draining instructions, and replace the
Drain Valve Washer
Replacement
NOTE: For replacement, use a _Y_2"x _/_" x _" thick washer available at your nearest hardware store. For ordering replace- ment washers, refer to the "Parts Order List" section.
Turn "OFF" gas supply to water heater. Follow "Draining" instructions.
Turning counter clockwise, remove the hex cap below the screw handle.
Remove the washer and put the new one in place.
Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.
Follow instructions in the "Filling The Water Heater" section.
Check for leaks.
Follow the lighting instructions in the "Lighting" section to restart the water heater.
_AND CAP
ASSEMBLY
WASHER
Housekeeping
Vacuum around base of water heater for dust, dirt, and lint on a regular basis.
Combustible materials such as clothing, cleaning materials, or
flammable liquids, etc. must not be placed against or adjacent to the water heater.
To insure sufficient ventilation and combustion air supply, prop-
er clearances from the water heater must be maintained at all times.
Service
Before calling for repair servicc, read the Start Up Conditions
and Operational Conditions found in the Troubleshooting Guide of this manual
If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at
21