Kenmore 116.29914 manual Cleaning Exterior and Attachments, Motor Safety Filter Changing, Ability

i CLEANING EXTERIOR AND ATTACHMENTS

1.Turn off and unplug vacuum cleaner. DO

NOT drip water on vacuum cleaner.

2.To clean exterior, or to reduce static elec-

tricity and dust build-up, wipe outer surface of vacuum cleaner and attachments. Use a

dean, soft cloth that has been dipped in a solution of mild {iquiddetergent and water, then wrung dry. Wipe dry after cteaning

CAUTION

Do not use attachments if they are wet° Attachments used in dirty areas, such as under a refrigerator, should not be used on other surfaces until they are washed. They could leave marks.

/ = nlllm uuluull,lll.ul=

MOTOR SAFETY FILTER CHANGING

iL, ,WARNING

Electrical Shock Hazard

Turn off and unplug vacuum cleaner

From electrical outlet. Do not operate the vacuum cleaner without the motor

safety filter. Be sure the filter is dry and

properly installed to prevent motor failure andlor electrical shock.

i i

2°Lift the rubber	..4L_,j_'_/_	----_
retainer and pull out
motor safety filter as
shown
	Retainer	S

MOTOR SAFETY FILTER

ELECTROSTATIC

This filter must be replaced when dirty It should be replaced regularly depending on use conditions° The filter CANNOT be washed as it will lose its dust trapping

ability.

NOTE: See PARTS AND FEATURES for Motor Safety Filter number

1oRemove the bag as outlined in the BAG CHANGING section.

,._ _		3oReplace the fitter,
		toward	dust bag, by
		sliding it back into
_		place under the ribs in
		white	side facing
		the bag cavity		Tuck
_iRubber	_" J	filter in so that		it fits
_Retainer_		completely under the
		rubber	retainer.

4.Replace the bag as outlined in the BAG CHANGING section.

I7