On-Q/Legrand 1307877 owner manual Federal Communications Commission Statement

Page 2

Federal Communications Commission Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

•This device may not cause harmful interference, and

•This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of the Federal Register, National Archives and Records Administration, U.S. Government Printing Office.

Canadian Department of Communications

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

FCC Radio Frequency Exposure Caution Statement

In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Use only with supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. Any changes of modifications not expressly approved by the grantee of this device could void the users authority to operate the equipment.

Installation and use of this Wireless LAN device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment. The manufacturer is not responsible for any radio or television interference caused by unauthorized modification of this device, or the substitution or attachment of connecting cables and equipment other than manufacturer specified. It is the responsibility of the user to correct any interference caused by such unauthorized modification, substitution or attachment. Manufacturer and its authorized resellers or distributors will assume no liability for any damage or violation of government regulations arising from failing to comply with these guidelines.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Declaration of Conformity (R&TTE directive 1999/5/EC)

The following items were completed and are considered relevant andsufficient:

•Essential requirements as in [Article 3]

•Protection requirements for health and safety as in[Article 3.1a]

•Testing for electric safety according to [EN 60950]

•Protection requirements for electromagnetic compatibility in[Article 3.1b]

301 Fulling Mill Road, Suite G

©Copyright 2005 by On-Q/Legrand, Inc All Rights Reserved.

Middletown, PA 17057

www.onqlegrand.com

(800)-321-2343

 

Page ii

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Wireless Access Point FCC Radio Frequency Exposure Caution Statement Federal Communications Commission StatementCanadian Department of Communications Declaration of Conformity R&TTE directive 1999/5/ECPage Table of Contents Introduction Data Rate Open Area Closed AreaII. Product Overview FeaturesReplacement Parts Components IncludedWAP 802.11g Reset Button Access WAP Assembly Status Indications P/N 364891-01 shownStatus Indicators Detailed Description Connection Area Detailed DescriptionPage III. Installation Rough-in stepsTrim-out steps Data in from ISP Data/Power IV. Configuration Steps Select Control Panel Double-clickNetwork and Dial-Up ConnectionsIs not applicable for Windows 98SE or ME Logging on to the WAP Wireless Security Setup Page Page Configuring the WAP 802.11g to work with a Router Allowing Client Access with MAC Addresses Is not applicable for Windows 98SE or ME Page Firmware Upgrades Login Password ChangeVI. Troubleshooting WAP 802.11g Assembly RemovalRestoring Factory Defaults Page Page Cannot configure the WAP 802.11g over the network Ascii VII. GlossaryAnsi BSSDMZ CPEDhcp DNSESS DSLDsss FTPIsdn IcmpIeee ISPNIC MTUNAT OSIPOE PcmciaPing PPPSmtp ROMRTS UDP TCPTCP/IP USBWEP WANWAP Wlan

1307877 specifications

The On-Q/Legrand 1307877 is a versatile and innovative multimedia wall plate designed to streamline home theater and audio/video (AV) setups. As part of Legrand’s On-Q product line, this wall plate offers a blend of functionality, aesthetics, and high-performance features that cater to the modern smart home environment.

One of the standout features of the 1307877 is its ability to support a variety of connections for audio and video signals. It includes multiple input options, such as HDMI, RCA, and speaker terminals, allowing users to connect various devices, from Blu-ray players to game consoles and streaming devices. This versatility ensures that users can enjoy high-definition video and high-fidelity audio through a single wall plate, reducing clutter and enhancing the overall aesthetic of the room.

The technology behind the On-Q/Legrand 1307877 is designed to optimize signal quality and reduce interference. The HDMI port supports 4K resolution and is capable of carrying audio signals as well, ensuring that users receive the best possible picture and sound quality from their devices. The wall plate is structured with high-quality materials that are not only durable but also designed to minimize signal degradation.

Another important characteristic of this wall plate is its ease of installation. The On-Q/Legrand 1307877 is built to fit into standard-sized electrical boxes, making it user-friendly for both professional installers and DIY enthusiasts. The included mounting hardware ensures a straightforward setup process, and the clean design blends seamlessly with home decor, providing a polished and professional look.

In addition to functionality, the 1307877 is designed with future-proofing in mind. As technology continues to advance, having a multimedia wall plate that can accommodate various connections and formats ensures that users can adapt their home entertainment systems without needing extensive renovations.

Overall, the On-Q/Legrand 1307877 multimedia wall plate stands out as a practical solution for modern AV needs, providing a combination of high-tech features, user-friendly installation, and aesthetic appeal. Its commitment to quality and performance makes it an excellent choice for anyone looking to enhance their home entertainment setup.
Top Page Image Contents