FIRE PROTECTION *
FIRE |
If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the EZ Touchpad will be flashing. If a Fire Alarm does occur:
*Note: This feature may not apply to your system. Consult your installer to determine if your system includes fire protection.
1 If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.
2 | If there is no evidence of a fire, press SILENCE OR insert your | |
The siren will silence, and FIRE on the EZ Touchpad will stop flashing, and light steady. | ||
|
Determine which device went into alarm. If you are protected by smoke detectors, the light on the
3 active detector will be lit. Once it is determined which smoke detector is in alarm, press SILENCE to reset the smoke detector.
4 | FIRE |
|
If the Fire Zone has reset properly, the FIRE light should go out in approximately 30 seconds. If it does not go out, press SILENCE again in a few minutes. If it still does not go out, call for service.
TBL |
The system is constantly monitoring the Fire Zone to insure the connections to the protective de- vices are in good working order.
•If a problem on a Fire Zone is detected, a System Trouble will display. The sounder will activate and the Trouble TBL light will blink 7 times.
Press the SILENCE button to silence the sounder. Call for service immediately.
15