Therma-Stor Products Group 90H owner manual 2A Install Instructions, 2B Wiring

Page 10

FOR HVAC INSTALLER ONLY

5.DEH 3000 Digital Control Installation Instructions

Control Part No. 4026570

5.1 Specifications

 

Part # (P/N)

4026570

Model:

DEH 3000 Digital Control

Electrical:

24 VAC

Humidity Range:

10 – 95% RH

Humidity Accuracy:

+/- 5%

Output:

3 Amps 24 VAC

Relay Capacity

5 Amps

Temp Range/Accuracy

2%

Size

4.95" wide x 4.19" high

FOR HVAC INSTALLER ONLY:

5.2 Installation

This control panel must be installed in the conditioned space and in accordance with all applicable codes and standards. Follow the instructions below when installing and setting this control.

5.2A Install Instructions

1.Separate the front panel from the back panel by depressing the middle sections of the top and bottom of the front panel.

2.Line the back panel up against the wall or flat surface onto which it is to be mounted and drill in the appropriate mounting holes.

3.Insert the screws and tighten down so they extend approximately 1/8” from the back plate.

4.Align the back panel so that the control is level.

5.Tighten the screws to lock into position.

6.Make the electrical connections to the terminals on the back panel as shown in the wiring diagram.

7.Reassemble the front to the back panel. Connect at the top first, then at the bottom.

8. Test connections (see Section 2.6)

5.2B Wiring

WARNING: DO NOT ALLOW THE YELLOW LEAD FROM THE ULTRA-AIRE TO CONTACT THE RED OR WHITE LEADS FROM THE ULTRA-AIRE OR DAMAGE TO THE TRANSFORMER WILL RESULT

WARNING: UNPLUG ULTRA-AIRE BASE UNIT BEFORE WIRING CONTROL.

The installer must supply the wiring between the Ultra-Aire and the control panel. Be sure to safely route the control wires to prevent damage during installation. Be careful not to cross the wires when connecting the Ultra-Aire and the remote control panel or damage to the transformer may result.

The remote control of the Ultra-Aire is powered by a low voltage circuit (24 VAC) and must NEVER contact or be connected to a high voltage circuit. Some of the control wires leaving the Ultra-Aire may not be used with certain control panels and should be left safely disconnected with wire nuts taped onto the stripped ends. Be sure to consult the electrical schematic in this manual or on the front panel of the Ultra- Aire before making the control connections.

10

Ultra-Aire 90H Installer’s & Owner’s Manual

Image 10
Contents Dehumidification 4025700 Serial NoFresh Air Ventilation optional Air FiltrationTable of Contents Safety Precautions Read and Save These InstructionsInstallation For Hvac Installer onlySpecifications Intended Application for Ultra-Aire 90H3B Condensate Pump Kit Condensate Water Removal3A Lifting Condensate Ducting4B Ducting for Fresh Air Option Exhaust fans are recommended in the bath rooms and kitchenNoise Abatement 4F Ducting for High Efficiency FiltrationControls Fan/Filter Switch For Hvac Installer and HomeownerHumidity Control Adjustment 6E DEH 2000 Digital Control with Fresh Air and Damper9C Automatic or Manual Mode Ventilation Timer9A Setting the Time 9B Ventilation Schedule2B Wiring 2A Install InstructionsDEH 3000 Digital Control Installation Instructions Dehumidification 2C Auxiliary relay operation2D Dehumidifier lockout/activation AC sensor Engage A/C during dehumidification2F Testing 2E Location3D Setting Clock Time 3B Setting3C On/Off Setting 3E Setting Relative Humidity Setpoint3F Fan Setting and Operation For Hvac Installer only and HomeownerOperation 3H Intermittent or Programmed Ventilation 3I Temperature Cutout Programming 3J Default SettingsDEH 3000 Digital Control High Efficiency Air Filter MaintenanceStandard Air Filter Optional Fresh Air IntakeUA-90H with Ventilation Timer/Humidity ULTRA-AIRE 90H Wiring DiagramWiring Diagrams UA-90H with Humidity/Fan Control 4024155 Fan ControlOptional Parts List UA-90H Indoor Air Quality System For Homeowner Routine Maintenance Service Parts List UA-90H Indoor Air Quality SystemTroubleshooting ServiceTechnical Description Electric Ventilation Damper Compressor/Capacitor ReplacementRefrigerant Charging Condensate Pump KitCondensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only ULTRA-AIRE 90H Dehumidifier Limited Warranty PO Box 8680 Madison, WI Phone 608-222-5301 Fax

90H specifications

Therma-Stor Products Group 90H is a cutting-edge climate control solution designed for both residential and commercial applications. Renowned for its efficiency and reliability, the 90H model stands out due to its advanced features that cater to various environmental conditions.

One of the key highlights of the Therma-Stor 90H is its dual functionality as both a dehumidifier and an air exchanger, making it a versatile choice for maintaining optimal indoor humidity levels. The unit is engineered to handle spaces up to 2,500 square feet, making it ideal for basements, crawl spaces, and larger living areas.

Incorporating state-of-the-art technologies, the 90H operates using an energy-efficient compressor that significantly reduces power consumption. This not only minimizes operational costs but also contributes to a more environmentally friendly solution. Furthermore, the unit is equipped with variable-speed fans that ensure quiet operation while delivering consistent airflow throughout the space.

Another notable feature of the Therma-Stor 90H is its advanced control system. The integrated humidity control allows users to set precise humidity levels, ensuring that air quality is maintained at optimal levels. The built-in hygrometer continuously monitors indoor humidity, automatically adjusting the unit’s performance to provide the most efficient dehumidification possible.

Durability and ease of use are also key characteristics of the 90H. Constructed with high-quality materials, the unit is designed to withstand the rigors of continuous operation. Its compact design allows for easy installation and portability, making it suitable for virtually any setting.

Additionally, the Therma-Stor 90H features a user-friendly interface with intuitive controls, allowing users to monitor and adjust settings effortlessly. The unit also includes a convenient drainage system, enabling continuous operation without the need for constant manual intervention.

In summary, the Therma-Stor Products Group 90H is an innovative solution for effective moisture management. With its dual-functionality, energy-efficient operation, advanced humidity control, and robust construction, it stands out as a premier choice for maintaining a healthy indoor environment. Ideal for both residential and commercial use, the 90H redefines how we think about climate control and air quality.