Therma-Stor Products Group Comprehensive Guide for Your Ultra Aire 90H Dehumidifier

Page 22

FOR HVAC INSTALLER ONLY

11. Service

CAUTION

CAUTION: Servicing the UA-90H with its high pressure refrigerant system and high voltage circuitry presents a health hazard which could result in death, serious bodily injury, and/ or property damage. Call your HVAC contractor.

11.1 Technical Description

The UA-90H uses a refrigeration system similar to an air conditioner’s to remove heat and moisture from incoming air, and add heat to the air that is discharged. Hot, high-pressure refrigerant gas is routed from the compressor to the condenser coil (See Figure 1). The refrigerant is cooled and condensed by giving up its heat to the air that is about to be discharged from the unit. The refrigerant liquid then passes through a strainer and capillary tubing which causes the refrigerant pressure and temperature to drop. It next enters the evaporator coil where it absorbs heat from the incoming air and evaporates. The evaporator operates in a flooded condition, which means that all the evaporator tubes contain liquid refrigerant during normal operation. A flooded evaporator should maintain nearly constant pressure and temperature across the entire coil, from inlet to outlet.

Refrigeration System of UA-90H

The mixture of gas and liquid refrigerant enter the accumulator after leaving the evaporator coil. The accumulator prevents any liquid refrigerant from reaching the compressor. The compressor evacuates the cool refrigerant gas from the accumulator and compresses it to a high pressure and temperature

11.2 Troubleshooting

No dehumidification, neither fan nor compressor run with fan switch and ventilation timer OFF.

1.Unit unplugged or no power to outlet.

2.Humidity control set too high or defective.

3.Loose connection in internal or control wiring.

4.Defective Compressor relay.

5.Defective control transformer.

6.Optional Condensate Pump Safety Switch open.

No dehumidification, compressor does not run but fan runs with fan switch and ventilation timer OFF and humidity control turned to ON.

1.Defective compressor run capacitor.

2.Bad connection in compressor circuit.

3.Defective compressor overload.

4.Defective compressor.

5.Defrost thermostat open.

6.Optional Condensate Pump Safety Switch open.

Fan runs with fan switch and ventilation timer OFF, but compressor cycles on and off.

1.Low ambient temperature and/or humidity causing unit to cycle through defrost mode.

2.Defective compressor overload.

3.Defective compressor.

4.Defrost thermostat defective.

5.Dirty air filter(s) or airflow restricted.

6.Low refrigerant charge, causing defrost control to cycle.

7.Bad connection in compressor circuit. Fan does not run with fan switch in either position.

Fan does not run with ventilation timer activated. Compressor runs briefly but cycles on & off with humidity control turned to ON.

1.Loose connection in fan circuit.

2.Obstruction prevents fan rotation.

3.Defective fan.

4.Defective fan relay.

5.Defective fan capacitor.

Fan runs with fan switch ON. Fan does not run with ventilation timer activated.

1.Defective ventilation timer.

2.Time not correct on ventilation timer.

3.Ventilation timer set to manual and switched OFF.

4.Defective fan switch.

Evaporator coil frosted continuously, low dehumidifying capacity.

1.Defrost thermostat loose or defective.

2.Low refrigerant charge.

3.Dirty air filter(s) or airflow restricted.

4.Excessively restrictive ducting connected to unit.

22

Ultra-Aire 90H Installer’s & Owner’s Manual

Image 22
Contents Dehumidification 4025700 Serial NoFresh Air Ventilation optional Air FiltrationTable of Contents Safety Precautions Read and Save These InstructionsInstallation For Hvac Installer onlySpecifications Intended Application for Ultra-Aire 90H3B Condensate Pump Kit Condensate Water Removal3A Lifting Condensate Ducting4B Ducting for Fresh Air Option Exhaust fans are recommended in the bath rooms and kitchenNoise Abatement 4F Ducting for High Efficiency FiltrationControls Fan/Filter Switch For Hvac Installer and HomeownerHumidity Control Adjustment 6E DEH 2000 Digital Control with Fresh Air and Damper9C Automatic or Manual Mode Ventilation Timer9A Setting the Time 9B Ventilation Schedule2B Wiring 2A Install InstructionsDEH 3000 Digital Control Installation Instructions Dehumidification 2C Auxiliary relay operation2D Dehumidifier lockout/activation AC sensor Engage A/C during dehumidification2F Testing 2E Location3D Setting Clock Time 3B Setting3C On/Off Setting 3E Setting Relative Humidity Setpoint3F Fan Setting and Operation For Hvac Installer only and HomeownerOperation 3H Intermittent or Programmed Ventilation 3I Temperature Cutout Programming 3J Default SettingsDEH 3000 Digital Control High Efficiency Air Filter MaintenanceStandard Air Filter Optional Fresh Air IntakeUA-90H with Ventilation Timer/Humidity ULTRA-AIRE 90H Wiring DiagramWiring Diagrams UA-90H with Humidity/Fan Control 4024155 Fan ControlOptional Parts List UA-90H Indoor Air Quality System For Homeowner Routine Maintenance Service Parts List UA-90H Indoor Air Quality SystemTroubleshooting ServiceTechnical Description Electric Ventilation Damper Compressor/Capacitor ReplacementRefrigerant Charging Condensate Pump KitCondensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only Condensate Pump Installation for Hvac Installer only ULTRA-AIRE 90H Dehumidifier Limited Warranty PO Box 8680 Madison, WI Phone 608-222-5301 Fax

90H specifications

Therma-Stor Products Group 90H is a cutting-edge climate control solution designed for both residential and commercial applications. Renowned for its efficiency and reliability, the 90H model stands out due to its advanced features that cater to various environmental conditions.

One of the key highlights of the Therma-Stor 90H is its dual functionality as both a dehumidifier and an air exchanger, making it a versatile choice for maintaining optimal indoor humidity levels. The unit is engineered to handle spaces up to 2,500 square feet, making it ideal for basements, crawl spaces, and larger living areas.

Incorporating state-of-the-art technologies, the 90H operates using an energy-efficient compressor that significantly reduces power consumption. This not only minimizes operational costs but also contributes to a more environmentally friendly solution. Furthermore, the unit is equipped with variable-speed fans that ensure quiet operation while delivering consistent airflow throughout the space.

Another notable feature of the Therma-Stor 90H is its advanced control system. The integrated humidity control allows users to set precise humidity levels, ensuring that air quality is maintained at optimal levels. The built-in hygrometer continuously monitors indoor humidity, automatically adjusting the unit’s performance to provide the most efficient dehumidification possible.

Durability and ease of use are also key characteristics of the 90H. Constructed with high-quality materials, the unit is designed to withstand the rigors of continuous operation. Its compact design allows for easy installation and portability, making it suitable for virtually any setting.

Additionally, the Therma-Stor 90H features a user-friendly interface with intuitive controls, allowing users to monitor and adjust settings effortlessly. The unit also includes a convenient drainage system, enabling continuous operation without the need for constant manual intervention.

In summary, the Therma-Stor Products Group 90H is an innovative solution for effective moisture management. With its dual-functionality, energy-efficient operation, advanced humidity control, and robust construction, it stands out as a premier choice for maintaining a healthy indoor environment. Ideal for both residential and commercial use, the 90H redefines how we think about climate control and air quality.