Heat & Glo LifeStyle CF550EV, CF750E 240VAC Hardwire Installation, Wall Switch Wiring 12VDC

C. 240VAC Hardwire Installation

(Minimum 14 gauge three conductor wire, non-metallic sheathing with ground.)

•Turn off circuit breaker.

•Remove access knockout located on the right side of heater.

•Disconnect black and white wires between the heater and plug. Remove the power cord. Remove the electrical knockout and install the cable clamp (not provided). Remove the connectors on the wires from the heater and strip them back 1/2 in.

•Feed 8 in. of service wire through cable clamp (not provided) and secure.

•Connect black, white and red wires of the heater to the black, white and red wires from the service. Connect green (ground) wire from heater to the ground of the service. See Figure 4.1.

•Wall switch wiring (see below) is to be done at this time.

•Cover the access hole with a 4 in. cover plate (not provided) if required.

•Remove the protective cover by cutting the tape located on the outer perimeter.

D. Wall Switch Wiring (12VDC)

*Do not connect wires to 120/240VAC* (hardwired heat- ers only)

•Turn off circuit breaker.

•Remove access knockout located on the right side of heater.

•Feed 8 in. of wire for the wall switch through the cable clamp and secure. Low voltage wire can be used for the wall switch connection. It is recommended to only go 10 ft from the heater to the wall switch.

•Locate the light blue (wall switch) wires in the heater. Connect one wall switch (blue) wire to wire for switch and connect the other wall switch (blue) wire to the other wire for switch.

•Cover the access hole with a 4 in. cover plate (not provided) if required.

•Run the wall switch wire to the wall box and connect to a wall switch (WSK-21 & WSK-21-W).

LAMP LAMP

120VAC

LAMPS

DIMMER

B

A

GROUND

NEUTRAL

120VAC 60Hz

LINE1 HOT

120VAC 60Hz	240VAC 60Hz
	LINE2 HOT

120VAC PLUG or 120/240VAC HARD WIRED

FLAME MOTOR	B	A
R2

SPEED CONTROL

-12VDC

OPTIONAL
		D1	THERMOSTAT
REMOTE OR	REMOTE		RELAY
		DIODE
WALL ON/OFF	HEAT
SWITCH	CONTROL
			HEAT SWITCH

-+

12VDC

SUPPLY

POWER	WHITE		BLOWER
		BLOWER
		120VAC
-12VDC	BLACK	HIGH LIMIT HEATER1	HIGH LIMIT
			HEATER1
			BLACK
			240VAC
	RED		HEATER2
			RED

3PIN WIRING HARNESS

120VAC - 240VAC 60HZ SPLIT-PHASE

POWER NEUTRAL MUST NOT CONNECT TO VIRTUAL NEUTRAL OF HEATERS OR BLOWER IN 240VAC VERSION

￿Figure 4.1 120V/240V Wiring Diagram

10 Heat & Glo • CRESTFIRE Series Electric Fireplace • 4030-239 Rev J • 04/05