10 Maintenance and Service
A. Cleaning the Firebox and Control Compart- ment
Keep the fi rebox, control compartment and heater system clean. Clean by brushing and vacuuming at least once a year. To access the control compartment, follow the instruc- tions for replacing the light bulbs. Follow the heater system maintenance instructions to access the heater system. Fail- ure to do this may shorten the fan’s life. Always disconnect power before performing any cleaning or maintenance.
B. Cleaning the Glass Doors and Back Acrylic Panel
The acrylic panel is cleaned in the factory during the assem- bly process. During shipment, installation, handling, etc., the acrylic panel surface may collect dust particles. These can be removed by buffi ng lightly with a clean dry cloth.
To remove fi ngerprints or other marks, the acrylic panel can be cleaned with a damp cloth using a mild soap and water solution. DO NOT USE GLASS CLEANER! IT WILL RUIN THE ACRYLIC PANEL! The acrylic panel should be com- pletely dried with a lint free cloth or paper towel.
In the event of acrylic panel breakage, vacuum all remain- ing pieces with a shop vac. DO NOT VACUUM IF PIECES ARE HOT! Replace acrylic panel with a panel ordered direct or through your local distributor only. Never use substitute material.
C. Replacing the Light Bulbs
The light bulbs will need to be replaced when the fl ame and/ or ember bed is dark on one side. Replace the bulbs with 75 watt halogen bulbs with
•Turn off circuit breaker or unplug heater before replacing the light bulbs.
•Open the lower grille panel to view the dashboard on the heater (the lower grille may need to be removed).
•Remove the four outer screws. See Figure 10.1.
•Pull dashboard towards you to expose the light compartment (the light compartment does not need to be pulled all of the way out of the heater).
•Carefully remove burned out bulb from light socket. Place new bulb in socket. Follow directions on light bulb package for handling requirements.
•Slide dashboard back into heater and make sure all wires are inside heater.
•Reinstall the four screws removed earlier.
•Turn on circuit breaker or plug heater back into wall outlet.
WARNING
Shock Risk
Burn Risk
Cleaning, performing maintenance or moving this electric heater without disconnecting power and allowing the heater to cool could create a shock or burn hazard.
•Turn controls to “OFF”.
•Remove plug from outlet or turn off the circuit breaker to the heater.
WARNING
Burn Risk
Accidental burning of the skin could occur.
•Allow at least 15 minutes for the light bulbs to cool before touching them.
Remove Screws |
Bulbs |
Remove Screws |
Figure 10.1 Replacing the Bulbs |
CAUTION
Handle glass assembly with care.
When cleaning glass door:
•Avoid striking, scratching or slamming glass.
•Do NOT use abrasive cleaners.
•Use a hard water deposit glass cleaner on white fi lm.
•Do NOT clean glass when it is hot.
Heat & Glo • CRESTFIRE Series Electric Fireplace • | 19 |