(long cycles), you may want to adjust the anticipation setting.
!CAUTION
A cooling anticipation setting of less than 10 may cause decreased compressor life.
SET
To adjust heat anticipation, press CLOCK
and DAYSET at the same time. The display will
show HEAT 5 (this is the factory prepro- grammed heating anticipation setting). You may select any anticipation setting from 2 to 40 (note that for hydronic systems, a minimum anticipation setting of 15 is recommended). Whenever adjusting an- ticipation, increase or decrease the dis- played number by only one or two digits, then let the system run for a while to see if
the adjustment is sufficient. If the heat
cycles are too short, press TIMEFWD to increase the cycle time. If the heat cycles are too
TIME
long, press BACK to decrease the cycle
time. To set cooling anticipation, press
SET | and | SET | at the same time again. |
CLOCK | DAY |
The display will show COOL 14 (factory preprogrammed cooling anticipation). You may select any anticipation setting from 4 to
40. Use the | TIME | and | TIME | buttons to |
FWD | BACK | |||
adjust anticipation. Press | RUN | to return | ||
PRGM | ||||
to your program.
•LOW BATTERY INDICATOR — The word BATTERY will flash on the display if the "AA" alkaline batteries are low and should
16