Desa CTDV36NR Optional Remote Operation, Ghrc Series Operation, Ghrcta Series Operation, Tions on

26

OPERATING FIREPLACE

Optional Remote Operation

OPERATING FIREPLACE

Continued

OPTIONAL REMOTE OPERATION

Note: All remote control accessories must be purchased sepa- rately (see Accessories, page 37). Follow instructions included with the remote control.

(Optional [C]GHRCT[A] Only) The thermostat control setting on the remote control unit can be set to any comfort level between HI and LO. The burners will turn on and off automati- cally to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.

NOTICE: You must light the pilot before using the hand-held remote control unit. See Lighting Instruc-

IMPORTANT: This remote control has been specially engineered to take an air temperature sample every 5.5 minutes in the auto mode. It will not respond immedi- ately to the temperature setting being turned up or down. IMPORTANT: The hand-held remote control unit must be near the heater. Do not keep the hand-held remote control unit too close to the heater. The thermostat on the hand-held remote control unit will heat up too quickly and turn the fireplace off.

3.To turn the burner off, press the AUTO/ON/OFF button until OFF lights. The pilot will remain lit.

IMPORTANT: To turn the pilot off, manually turn the con- trol knob on the heater to the OFF position.

tions on page 25.

1. After lighting, let pilot flame burn for about one minute. Turn

gas control knob to ON position. Adjust variable control knob

anywhere between HI and LO. Slide the selector switch to the

REMOTE position (see Figure 53). Note: The burners may

light if hand-held remote ON button was on when selector

switch was last turned off. You can now turn the burners on

and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the RE-

MOTE position when the pilot is not lit. This will drain the

battery.

Blower Control Knob (Optional Accessory)

OFF

ON

REMOTE

OFF

ON

Selector Switch in

Remote Position

Variable

Control Knob

N		L
O		O	I
T	F	O	H
O
	F
LIP

Gas Control Knob in ON Position

IMPORTANT: Be sure to press the ON/OFF buttons on the

hand-held remote control unit for up to 3 seconds to assure

proper operation.

Figure 52 - Setting the Selector Switch, Gas Control Knob, and Variable Control Knob for Remote Operation

GHRC Series Operation:

2a. Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.

GHRCT(A) Series Operation:

2b. Press the AUTO/ON/OFF button on the hand-held remote control (see Figure 54). The lights to the left of the button will show AUTO, ON, or OFF.

•	In the ON mode, the burners will ignite. The heater is in
	manual mode when ON is lit.
•	In the AUTO mode, the thermostat in the hand-held re-
	mote unit controls the room temperature. To increase the

Shows

Temperature

Setting

The Log Heater will Automatically Cycle between Pilot and the Heat

Setting that has been Selected

Increases Room

Temperature in

AUTO Mode

Decreases Room

Temperature in

AUTO Mode

Turns Burners On

or Off and Allows

You to Choose the

Auto Setting

room temperature, press the top arrow of the TEMP but-

ton. To lower the room temperature, press the bottom

arrow of the TEMP button. At higher settings the heater

will run longer.

Figure 53 - Thermostat Hand-Held Remote Control Unit Selections ([C]GHRCT[A] Series Only)

For..com

108661-01D