INSTALLATION
Continued
NOTICE: If your installation does not meet the minimum clear- ances shown, you must do one of the following:
•raise the mantel to an accept- able height
•remove the mantel
Note: All vertical | Mantel Shelf | |||
|
|
|
| |
measurements | 10" |
|
|
|
are from top |
|
|
| |
8" |
|
|
| |
of fireplace |
|
|
| |
|
|
|
| |
opening to | 6" |
|
|
|
|
|
| ||
bottom of | 2 1/2" |
|
|
|
|
|
| ||
mantel shelf. |
|
|
|
|
Minimum Non- |
|
|
|
|
Combustible |
|
|
|
|
Material | 13" | 16" | 19" | 21" |
| ||||
|
|
|
|
|
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set trim assembly aside for later installation.
Slot
Set Screws | Top | |
| ||
| Trim | |
Shim | Mitered | |
Edge | ||
|
Side
Adjusting
Trim
Plate
Slot
Figure 10 - Assembling Trim
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the man- tel for assembly instructions. Refer to instructions below for system installation. If using blower ac- cessory (see Accessories, page 32), see installation instructions on pages 12 through 15.
1.Choose location for fireplace and install gas supply line.
2.Remove screen from fireplace by removing screws in each end of screen rod (see Figure 11). Hold screen rod cover while removing five hex head screws underneath hood (see Figure 12). Carefully lift and pull out hood (see Figure 13, page 12).
Figure 9 - Minimum Mantel Clearances
for Built-In Installation
REMOVING BRICK LINER
RETAINER
1.Using Phillips screw driver, remove 2 screws attaching brick liner retainers to vertical sides.
2.Remove brick liner retainers and discard. Replace 2 screws into vertical sides.
ASSEMBLING TRIM
(Trim shipped with mantel)
1.Remove packaging from three pieces of trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 10.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 10).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 10).
Figure 11 - Removing Screen
Hood
Screen Rod
Cover
Screw
Figure 12 - Removing Hood Screws
www.desatech.com | 11 |