Desa CF26PTA installation manual Installing Blower Bracket Assembly

Page 13

INSTALLATION

Continued

8.Insert the 4 wire harness into one of the round holes in the rear of the blower control shield and through the rectangular hole in the front of shield (see Figure 16).

9.Reconnect red wire to the AUTO switch posi- tion. Reconnect blue wire to the ON switch position. Reconnect green and white wires to the power cord.

10.Install the switch plate on the blower control shield with 2 - #10 screws provided (see Fig-

ure 17). Route power cord out of the cabinet by inserting it through the bushing on the outer casing (see Figure 16). Plug fan kit into 120-Volt grounded power supply and test operation. Note: When switch is in the AUTO position, the fan will start after the heater has run for a few moments. The fan will continue to run for several moments after the heater has been turned off. When switch is in the ON position, the fan will run until turned to OFF. Reinstall hood assembly and close lower louver door.

Wiring Routing Hole

Blower Bracket

Assembly

Screw

Heat Deﬂector

Switch
	Wire Harness
	Power
	Cord
	Red
Blue
Switch Plate	Wire
	Wire
	Harness
Blower
Control
Shield

Shield Cover

Figure 16 - Installing Blower Bracket Assembly

Blower Control

Shield

Switch Plate Screw Figure 17 - Installing Switch Plate to Blower Control Shield

113896-01A

www.desatech.com

13

Image 13

Contents What to do if YOU Smell GAS Table of Contents Safety Information Unpacking Local CodesSafety Pilot Product FeaturesProduct Identification Piezo Ignition SystemDetermining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationUnusually Tight Construction Conﬁned and Unconﬁned SpaceVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Check GAS Type InstallationLocating Fireplace Rough Opening for Installing Wall BUILT-IN Fireplace InstallationAttaching Fireplace to Wall Studs Mantel Clearances for Built-In InstallationRemoving Brick Liner Retainer Optional Mantel InstallationAssembling Trim Trim shipped with mantelRemoving Hood Installing Blower Assembly GA3450TInstalling Blower Bracket Assembly For Built-In Installation Installation Items Needed Connecting to GAS SupplyPropane/LP Connecting Fireplace to GAS SupplyNatural From Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig KPaPressure Testing Heater GAS Connections Installing LogsOperating Fireplace For Your Safety Read Before LightingLighting Instructions Inspecting Burners Manual Lighting ProcedureTo Turn OFF GAS To Appliance Thermostat Control OperationBurner Flame Pattern Cleaning MaintenanceBurner Primary AIR Holes Main BurnerBlow air into the primary air holes on the injector holder CabinetObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte On windows Tilation air Gas leak. See Warning Replacement Parts SpecificationsService Hints Technical ServiceModels CF26PTA and CF26NTA Illustrated Parts BreakdownParts List 20-1 11-1 20-3 11-2 KEY Part Number Description QTY Parts Central AccessoriesEquipment Shutoff Valve GA5010 Thermostatically Controlled Blower KIT GA3450TCabinet Mantel with BUILT-IN Hearth Base Cleaning KIT GCKCabinet Mantel with Full Hearth Base Information Video113896-01A 113896-01A Keep this Warranty Warranty InformationLimited Warranty VENT-FREE GAS BAY Front Fireplace