Desa CD42M, CD32M(-1)(-2), CD36M(-1)(-2) Framing Dimension, Corner Installation, Duplex Outlet

Refer to the following table for clearance between roof and termination.

ROOF PITCH	MINIMUM HEIGHT ABOVE ROOF
	ft	mm
FLAT - 7/12	1	305
7/12 - 8/12	1.5	457
8/12 - 9/12	2	610
9/12 - 10/12	2.5	762
10/12 - 11/12	4	1219
12/12 - 14/12	5	1524
14/12 - 16/12	6	1829
16/12 - 18/12	7	2134
18/12 - 20/12	7.5	2286
20/12 - 21/12	8	2438

FRAMING

Once the final location has been determined (observing clearances for vent termination), you may construct framing using dimensions shown in figures 8 and 9, depending on the particular installation.

Figure 8	FRAMING DIMENSION
	CD32M	CD36M	CD42M
A	32-3/8"	36-1/8"	40-1/8"
B	34-5/8"	41-1/4"	48-1/4"

If the appliance is to be installed directly on carpeting, tile (other than ceramic), or any combustible material other than wood flooring, the appliance must be installed upon a metal or wood panel extending the full width and depth of the fireplace.

Figure 9	CORNER INSTALLATION
	CD32M	CD36M	CD42M
A	28-1/2"	35-3/4"	41-5/8"
B	13-5/8"	15"	21-5/8"
C	39-3/8"	49-5/8"	58-1/2"
D	9-1/2"	10-3/8"	13-1/2"
E	9-7/8"	13-3/4"	16-3/4"
F	34-1/2"	41-1/8"	48"
G	35-1/2"	42-1/8"	48-1/4"
H	54-3/8"	68-1/4"	81-1/2"

ELECTRICAL HOOK-UP AND REMOTE RECEIVER DIAGRAM

A wire way with two receptacles has been supplied for your convenience and is located on the lower right hand side of the appliance (see figure 10).

Figure 10 DUPLEX OUTLET

-6 - For more information, visit www.desatech.com