Installing LOGS, Lava Rock and Glowing Embers

FIREPLACE INSTALLATION

Installing Optional Brick Liner Models BL32D, BL36D(S), BL36DH(S) Installing Logs, Lava Rock and Glowing Embers

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL BRICK LINER MODELS BL32D, BL36D(S), BL36DH(S)

WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.

This brick liner kit is optional. You may purchase brick liner from your local retailer or see Accessories, page 31.

CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.

1.Remove top and bottom louvers to allow access to door latches.

2.Remove screen, unlock door latches and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 21.

3.If installing brick liner in new fireplace, go to step 4. If install- ing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.

4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.

5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 38).

6.Install top brick panel ([V]T36 Series only) by resting on the top of the rear panel. Hold the top brick panel in place and in- stall left side brick panel by sliding it between the grate and the side of the firebox, securing top panel (see Figure 39).

7.Install the right brick panel using the same method described

8.Replace deflector shield using screws removed in step 4.

9.Follow instructions on page 23 to install logs, lava rock, and ember material.

10.Close glass door, lock latches on top and bottom of door and replace screen (see Removing/Replacing Glass Door, steps 5 and 6, page 21).

11.Close top and bottom louvers.

Rear Brick Panel

Figure 38 - Installing Rear Brick Panel

Top Brick

Panel (T36

Series Only)

Left Side

Brick Panel

Figure 39 - Installing Left Side and Top Brick Panels

INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS

Note: 36" models shown. Logs will vary slightly for 32" models.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.

Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, pages 21 and 22. Install logs according to instructions for fireplace model numbers.

1.Place log #1 (rear log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 40).

2.Rest log #2 (front log) on the pins on the front part of the grate (see Figure 41).

1 2