Desa P324E, VP324E, P325E, VP325E Cleaning Maintenance, Burner Flame Pattern, Pilot and Burner

INSPECTING BURNERS

Burner Flame Pattern

CLEANING AND MAINTENANCE

Pilot and Burner

Logs

17

INSPECTING BURNERS

Continued

BURNER FLAME PATTERN

Burner flames will be steady; not lifting or floating. Flames should go up through the middle of logset. Flames should not "spill" to the edges of the pan or sides of the logset.

Figure 36 shows a typical flame pattern. If burner flame pattern differs from that described:

•turn appliance off (see To Turn Off Gas to Appliance, page 16)

•see Troubleshooting, pages 19 and 20

P324E and VP324E Models

CLEANING AND

MAINTENANCE

WARNING: Installation and repair should be done by a qualified service person. The appliance should be inspected before each use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bed- ding material, pet hair, etc. It is imperative that the control compartments, burners, and circulating air sys- tem be kept clean.

WARNING: The logs can be hot. Handle only when cool.

WARNING: Turn off gas and electrical power before servicing appliance.

PILOT AND BURNER

•Remove logs and ember material before cleaning burner and replace when cleaning is complete.

•Burner and controls should be cleaned with compressed air to remove dust, dirt, or lint.

•Use a vacuum cleaner or small, soft bristled brush to remove excess dust, dirt, or lint.

LOGS

• If you remove logs for cleaning, refer to log placement informa- tion on pages 12 and 13 to properly replace logs.

• Use a vacuum cleaner to remove any carbon buildup on logs.

• Replace log(s) if broken. See Replacement Parts, page 18.

• Replace ember material periodically as needed. See Replace- ment Parts, page 18.

P325E(B) and VP325E(B) Models

Figure 36 - Typical Flame Pattern

For more information, visit www.desatech.com

108794