Installation, Chimney Supports, 7412961

STR/CVR Series Woodburning Fireplaces

Chimney Supports

The chimney system is supported by the ﬁreplace for vertical chimney heights less than 20' (6m) above the hearth. Chimney supports are required if the vertical height exceeds 20' (6m). Locate chimney supports at ceiling holes or other structural framing at 20' (6m) heights. Spacing between chimney supports must not exceed 20' (6m). Use Chimney Support Model SKCS8 for SK8 chimney, and Model 11CS for 11CF chimney.

(NOTE: the chimney support can not be mounted directly to the ﬁreplace.) Support provided by elbow straps fulﬁlls the support requirement only if they are spaced as previously described. (A chimney support is 2¹⁄₂" (64mm) long when installed.)

Angled chimney runs require a support every 6' (1.8m) in addition to the elbow straps. Chimney supports are used for this function. (Fig. 9)

Chase Installation

A chase is a vertical box-like structure which encloses the ﬁreplace and/or chimney. Chases are typically built on the outside of the house with ﬁreplace opening cut into the outer wall of a room. (Page 5, Fig. 4)

If you need help in determining ﬁreplace location or how the chimney system should be run, contact your Majes- tic dealer for assistance.

Chimney Sup- port Strap

SKCS8

FP284

Fig. 8 Chimney support installation

Installation

Insulating Fireplace Enclosure for Cold

Climates

If you live in a cold climate, it is not required but highly recommended that you insulate ﬁreplace enclosure to eliminate cold air penetration as much as possible.

Insulate base of ﬁreplace with a non-combustible insulation rated for a minimum of 300°F. Insulating is very important for outside wall installations over a concrete slab. If ﬁreplace is installed on a platform, insulation should be placed on top of the platform before ﬁreplace is set. (Fig. 9)

When a ﬁreplace is installed in a chase or on a outside wall, enclosure should be treated like any outside wall in a home. Insulation should be installed on the inside wall as well as the outside wall(s). In a chase, it is also a good idea to install a ﬁrestop at the ﬁrst ceiling level above the ﬁreplace and enclose the chase with sheeting material. Insulation may then be installed above sheeting material to assure the space around the ﬁreplace is totally protected. (Fig. 4)

When installing the chimney, DO NOT caulk be- tween outer pipe and ﬁrestop. It is vital that some air be allowed to ﬂow through this very thin gap.

CAUTION: WHEN INSTALLING A FIREPLACE IN AN INSULATED ENCLOSURE, BE SURE ALL REQUIRED AIR SPACES ARE MAINTAINED. (Page 14, Fig. 20)

7412961