Chase Installation

Angled chimney runs require a support every 6’ (1.8m) in addition to the elbow straps. Chimney supports are

used for this function. (Fig. 6)

A chase is a vertical box-like structure which encloses the ﬁreplace and/or chimney. Chases are typically built on the outside of the house with ﬁreplace opening cut into the outer wall of a room. (Page 4, Fig. 2)

If you need help in determining ﬁreplace location or how the chimney system should be run, contact your Majestic Fireplaces dealer for assistance.

Chimney

Support

Strap

SKCS8

FP284

Fig. 6 Chimney support installation.

CR Series Woodburning Fireplaces

Installation

Insulating Fireplace Enclosure For

Cold Climates

If you live in a cold climate, it is not required but highly recommended that you insulate ﬁre- place enclosure to eliminate cold air penetration as much as possible.

Insulate base of ﬁreplace with a non-combus- tible insulation rated for a minimum of 300°F. Insulating is very important for outside wall installations over a concrete slab. If ﬁreplace is installed on a platform, insulation should be placed on top of the platform before ﬁreplace is set.(Fig. 7)

When a ﬁreplace is installed in a chase or on an outside wall, enclosure should be treated like any outside wall in a home. Insulation should be installed on the inside wall as well as the outside wall(s). In a chase, it is also a good idea to install a ﬁrestop at the ﬁrst ceiling level above the ﬁreplace and enclose the chase with sheet- ing material. Insulation may then be installed above sheeting material to assure the space around the ﬁreplace is totally protected. (Fig. 2)

When installing the chimney, DO NOT caulk between outer pipe and ﬁrestop. It is vital that some air be allowed to ﬂow through this very thin gap.

CAUTION: WHEN INSTALLING A FIRE- PLACE IN AN INSULATED ENCLOSURE, BE SURE ALL REQUIRED AIR SPACES ARE MAINTAINED. (Page 12, Fig. 17)

20001316