Operation
Electric Fireplace Manual Control
The manual controls for the fireplace are located in the upper right hand corner (Figure 4).
Figure 4
C B A
A. On/Off Switch
Supplies power to the
B.
Remote (left position): The unit is operated with the remote control.
Flame (center position): The
flame effect is turned on.
Flame & Heat (right position):
The flame effect and heater are turned on simultaneously. When the manual control is in the Flame
&Heat position the heater does not run on the remote operated thermostat.
!NOTE: When the
switch is in the Flame or Flame & Heat positions, the fireplace unit will not operate with the remote control.
C. Initialization Button
Used to synchronize the remote control with the fireplace.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic switch will turn the heater off and it will not come back on without being reset. The temperature cutoff switch can be reset by unplugging the unit, waiting five (5) minutes and plugging the unit back in.
CAUTION: If you need to continuously reset the heater, unplug the unit and call Dimplex North America Limited at
Remote Control
The remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with 243
11