Maintenance
Figure 9
Exploded view to show detail
Flicker Rod | Flicker |
Bulbs (3) | Motor |
into the rubber bushing on the flicker motor shaft (Figure 9).
6.Unscrew bulbs counter clockwise.
7.Insert new bulbs.
8.Reconnect the log set LED wire harness.
9.Install the log set by placing the front, bottom edge of the ember bed in the track behind the front panel. Once in place, push down on the back edge of the ember bed until the rear tab snaps into place under the Partially Reflective
Glass (Figure 10).
!NOTE: Ensure the log set is installed tightly under the back ledge to prevent light leakage.
10.Replace glass assembly.
Upper Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs
Figure 10
Back
LedgeLog
Ember Bed
Rear
Tab
|
|
|
|
| |
|
|
| Fr | ||
|
|
| ont | ||
| Side Section |
| Edge | ||
|
| ||||
| |||||
with an
Do not exceed 15 Watts per bulb.
To access the upper light bulb area:
1.Remove front glass assembly.
2.Upper bulbs are located in the upper left and upper right corners of fireplace (Figure
8).
3.Remove the upper light cover for each bulb (two (2) Philips screws each).
4.Unscrew bulbs counter clockwise.
5.Insert new bulbs.
6.
7.Replace glass assembly.
17