Operation
independent frequencies to prevent interference with other units.
Battery Installation
1.Depress tab on the battery cover on the back of the remote control and remove battery cover (Figure 5).
2.Install two (2) AAA batteries into the remote control (included).
3.Ensure child lock is in the “unlocked” position (Figure 5).
4.Replace the battery cover.
!NOTE: When the “BAT” symbol is present on the remote control it is recommended to replace the batteries promptly, to maintain full functionality of the remote/ fireplace. The remote control has a battery backup time of only several hours.
Battery must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area.
Figure 5
Batteries |
Child Lock |
Initializing/Reprogramming the Remote Control
1.Plug cord into 120 Volt wall outlet.
2.Ensure the On/Off Switch located in the switch box on the fireplace in the upper right hand corner is in the 
ON position (Figure 4A).
3.Set the 3 Position Manual Control (Figure 4B) to the Remote position (left position).
4.Press and hold the Initialization Button on the unit (Figure 4C).
5.While holding the Initialization Button, press the Flame/ Heat On/Off 
button on the remote control.
6.Release the Initialization Button on the unit.
12 | www.dimplex.com |