Trouble Shooting, Problem Cause Solution | Enviro EG-40 instruction

9. TROUBLE SHOOTING

Problem	Cause	Solution
Spark will not light the pilot after	Defective ignitor	Check connections to ignitor
repeated pressing of spark ignitor		-If ignitor connections are
		good but there is no spark-
		replace ignitor

	Miss aligned spark electrode	-Check for spark arcing from
		the electrode to pilot if not
		adjust by loosening screws
		on pilot base. Adjust and re-
		tighten

Pilot will not remain lit	Defective thermocouple	-check for proper connection
		of thermocouple to rear of
		valve

	Air in gas line	-bleed line
		-contact dealer

Burners will not light when valve and	Defective switch	-check switch connections
burner switch are both on		jump wires at switch

	Defective thermopile	-check connections to valve
		-check voltage across TP
		terminals
		(> 250 MV closed circuit)
		-contact dealer

	Thermostat set to low / defective	-Turn up the thermostat to
		start unit. Check thermostat
		connections

	Defective spill switch or Severe down	-check connections
	draft.	-check draft
		-contact dealer

Glass fogs up	Normal conditions - after the appliance
	warms up glass will clear
	Due to additives in gas glass may dirty

Blue flames	Normal during start - flame will yellow as
	the appliance heats up.

Sooting	Flame impingement	-check log position
		-increase primary air by
		opening shutters