Enviro EG-40 owner manual Table of Contents, Code Approvals, Specifications

WARNING; for installation only in a solid fuel burning fireplace with a working flue and

constructed of non-combustible material.

FOR INSTALLATIONS ABOVE 2000 FEET

	TABLE OF CONTENTS
1	Code Approvals	3
2	Specifications	3
3	Assembly and Installation Instruction	4
4 Deciding Where to Locate Your Stove………………………………………………..5
5	Venting	7
6	Installation of Log Sets and Embers	8
7	Operating Instructions	9
8	Routine Maintenance	10
9	Trouble Shooting	11
10	Gas Line Connection	12
11	Electrical Requirements	13
13	Parts and Accessories	14
	Air Shutter Adjustment	15
14	Warranty	16
15	Installation Data Sheet	17

1. CODE APPROVALS

Canadian Standards Association has tested these appliances, and found them to comply with the established standards for GAS FIRED VENTED ROOM HEATER in CANADA and the USA as follows:

ENVIROGAS EG-40 VENTED ROOM HEATER (EG-40 FPI BV Nat & LPG.)

TESTED TO: ANSI Z21.11.1-1991,Z21.11.1A.-1193 CAN 1-2.1M 86.

2. SPECIFICATIONS

ENVIROGAS 40 (FIREPLACE INSERT) VENTED ROOM HEATER

Vented Type, designated by the suffix BV, this unit must be vented through a conventional chimney with a

certified chimney liner kit.

•Has been certified for use with either natural or propane gases. (See rating label.)

•Is not for use with solid fuels.

•Is approved for bedroom or bedsitting room.

•Must be installed on a non-combustible surface.

•Must be installed in accordance with local codes.

If none exist use current installation code CAN/CGA B149 in Canada or ANSI Z223.1/NFPA 54 in the USA.

•Must be properly connected to a venting system.

•In Canada, these appliances are certified for altitudes of 0-2,000 feet and must be derated by 10% for installation at elevations between 2,000 and 4,500 feet.

•In the USA, this appliance is certified for elevations up to 2,000 feet. For elevations above 2,000 feet, input should be reduced 4% for every 1,000 feet above sea level.

The efficiency rating of this appliance is a product thermal efficiency rating determined under continuous

operating conditions and was determined independently of any installed system.

3