INSTALLATION
BEFORE YOU START
Safe installation and operation of this appliance requires common sense, however, we are required by the Canadian Safety Standards and ANSI Standards to make you aware of the following:
INSTALLATION AND REPAIR SHOULD BE DONE BY A QUALI- FIED SERVICE PERSON. THE APPLIANCE SHOULD BE IN- SPECTED BEFORE USE AND AT LEAST ANNUALLY BY A PRO- FESSIONAL SERVICE PERSON. MORE FREQUENT CLEANING MAY BE REQUIRED DUE TO EX- CESSIVELINTFROMCARPETING, BEDDING MATERIAL, ETC. IT IS IMPERATIVE THAT CONTROL COMPARTMENTS, BURNERS AND CIRCULATING AIR PAS- SAGEWAYS OF THE APPLIANCE BE KEPT CLEAN.
DUE TO HIGH TEMPERATURES, THE APPLIANCE SHOULD BE LOCATED OUT OF TRAFFIC AND AWAY FROM FURNITURE AND DRAPERIES.
WARNING: FAILURE TO INSTALL THIS APPLIANCE CORRECTLY MAY CAUSE A SERIOUS HOUSE FIRE AND WILL VOID YOUR WAR- RANTY.
CHILDRENANDADULTSSHOULD BE ALERTED TO THE HAZARDS OF HIGH SURFACE TEMPERA- TURES, ESPECIALLY THE FIRE- PLACE GLASS, AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISEDWHEN THEY ARE IN THE SAME ROOM AS THE APPLIANCE.
CLOTHING OR OTHER FLAM- MABLE MATERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.
IMPORTANT MESSAGE
The CLASSIC Freestanding Gas Stove must be installed in accordance with these instructions. Carefully read all the instructions in this manual first. Consult the "authority having jurisdiction" to determine the need for a permit prior to starting the installation.
GENERAL SAFETY
INFORMATION
1)The appliance installation must conform with local codes or, in the absence of local codes, with the current Canadian or National Gas Codes,
2)The appliance when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with the current National Electrical Code, ANSI/NFPA 70 or CSA C22.1 Canadian Electrical Code.
3)This appliance is Listed for bedroom instal- lations when used with a Listed Millivolt Thermostat. Some areas may have further requirements, check local codes before installation.
4)This appliance is Listed for Alcove instal- lations, maintain minimum Alcove clear- ances as follows, minimum ceiling height of
5)This unit is not approved for installation into a mobile home.
6)See general construction and assembly instructions.
7)This appliance must be connected to a vent and terminate to the outside of the building envelope. Never vent to another room or inside a building.
8)Inspect the venting system annually for blockage and any signs of deterioration.
9)Any safety glass removed for servicing must be replaced prior to operating the ap- pliance.
10)To prevent injury, do not allow anyone who is unfamiliar with the operation to use the fi replace.
11)Wear gloves and safety glasses for protec- tion while doing required maintenance.
12)Under no circumstances should this ap- pliance be modifi ed. Parts that have to be removed for servicing should be replaced prior to operating this appliance.
13)Installation and any repairs to this appliance should be done by a qualifi ed service person. A professional service person should be called to inspect this appliance annually. Make it a practice to have all of your gas appliances checked annually.
14)Do not strike the glass door.
15)Under no circumstances should any solid fuels (wood, paper, cardboard, coal, etc.) be used in this appliance.
16)The appliance area must be kept clear and free of combustible materials, (gases and other fl ammable vapours and liquids).
Emissions from burning wood or gas could contain chemicals known to the State of Cali- fornia to cause cancer, birth defects or other reproductive harm.
INSTALLATION
CHECKLIST
1)Locate appliance. Refer to the "Clearance to Combustible" section.
2)Install Optional Fan. Refer to the "Optional Fan Installation" section.
3)Assemble stove base - pedestal or legs. Refer to "Pedestal Assembly" or "Leg and Bottom Shield Assembly" section.
4)If using outside air. Refer to the "Optional Outside Air" section.
5)Install venting. Refer to the "Venting" section.
6)Make gas and electrical connections. Refer to the "Gas Connection" section.
Test the pilot. Must be as per diagram in the "Pilot Adjustment" section.
7)Test gas pressure. Refer to the "Gas Pipe Pres- sure Testing" section.
8)Test for fl ue spillage. Refer to the "Test for Fuel Spillage" section.
9)Install standard and optional features. Refer to the following sections where applicable:
a.Log Set Installation
b.Remote Control
c.Remote Wall Switch
d.Wall Thermostat
11)Final check. Refer to the "Final Check" sec- tion.
Before leaving this unit with the customer, the installer must ensure that the appliance is fi ring cor- rectly and operation fully explained to customer.
6 | Regency® CLASSIC |