Lopi Freedom Fireplace Insert owner manual Surround Panels, Installation Instructions

32 Optional Equipment

Surround Panels

SURROUND PANEL SIZE	HEIGHT	WIDTH	PART #
8"	29-1/2"	45-3/8 "	99300293
10"	31-1/2"	49-3/8 "	99300294
12"	33-1/2"	53-3/8 "	99300295

Installation Instructions

1.With the insert 12” from the fireplace, install the side surround panels (see the directions to the right).

2.Adjust the position of the side panels so they are: 1) flush with the bottom of the insert; 2) both the same distance back from the front of the insert; 3) perpendicular to the floor (use the top panel, if necessary, to judge alignment). Tighten the screws that hold the side panels in place.

3.Place the insert into the fireplace and connect the flue. Install the top panel and trim following the directions to the right.

Convection

Channel

Spring

Clips

Top

Panel

Install the top panel so the tabs insert into the joggle clips on the top panel

NOTE:

The inner flange on the panel fits into the convection channel.

Attach the side panels using the included screws & nuts.

3/8" Nutdriver

Micro (1/16”)

Standard

Screwdriver

Top Trim

"L" Bracket

Right Side

Trim

Optional Trim Installation:

Insert one leg of each "L" bracket into the top and side trim piece. Align the trim to form a precise corner, then tighten the two set screws with a small standard screwdriver. Slide the trim over the panels. Place the spring clips behind the panels at the locations shown. This keeps the trim tight against the panel.

Optional Knock-Out

An optional knock-out is provided on both sides if the power cord is routed behind the surround panel.

© Travis Industries 100-01162 4041105