Lopi Freedom Fireplace Insert owner manual Optional Equipment, Door Shell Installation

Page 29

Optional Equipment

Door Shell Installation

1. Remove the door retainer shipping latch following the directions below.

Standard

Screwdriver

Rotate this shaft

1/4 turn clockwise

until the door

unlatches.

Swing the door retianer open. Remove and discard the shipping latch and nut.

Shipping Latch

Door Retainer

9/16" Wrench

2.Place the door shell face down on a non-scratching surface. Lift the door retainer off the hinges. Insert the retainer into the door shell following the directions below. Note how the door shell is guided into place

Door Retainer

Door Shell

The indent on the door retainer slides into

the clip on the door shell (on both sides).

100-01162

4041105

Image 29

Contents Freedom Fireplace Insert Introduction Important Information Mail your Warranty Card Today, and Save Your Bill of Sale2Introduction Table of Contents Ashes Safety PrecautionsMobile Travis Industries, Inc. grants no warranty, implied orFeatures & Specifications Preparation for Installation Planning The InstallationAdditional Accessories Needed for Installation Installation ConsiderationsFireplace Requirements Minimum Fireplace SizeMasonry Fireplace Requirements Insert Placement RequirementsHearth Requirements Drafting Performance Leveling Bolt InstallationBlock-Off Plate Template Block-Off Plate InstallationInsert with Positive Insert with Direct Connection Masonry Operating Your Appliance Safety NoticeBefore Your First Fire Opening the DoorBypass Operation Starting a Fire Ash Removal Adjusting the Burn RateApproximate Air Control Settings Re-Loading the Stove Optional Blower OperationOvernight Burn Normal Operating SoundsWhy Dry Wood is Key Testing Wood MoistureHints for Burning Selecting WoodTroubleshooting Clean the Glass if necessary Daily Maintenance while stove is in useMaintaining Your Appliance Remove Ash if necessaryCreosote Formation and Need for Removal Monthly Maintenance while appliance is in useDoor and Glass Inspection Cleaning the Air Duct and Blower if applicable Yearly MaintenanceTouch Up Paint Firebrick and Baffle InspectionReplacing the Glass Door PartsReplacing the Door Gasket Replacing the Door HandleFirebox Parts Floor and Side Firebrick Removal & ReplacementAir Tube Removal & Replacement Baffle Removal & ReplacementYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyYears 3 Through 5 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyListing Label Listing LabelOptional Equipment Door Shell InstallationHex Wrench Flush Kit Surround Panels Installation InstructionsFront Blower To Switch The Power Cord To The Left SideIndex