Weil-McLain GV90+ manual Every Months, END Season, Oil blower motor, Operate boiler relief valve

Page 9

GV90+ gas-fired water boiler — User’s Information Manual

User maintenance procedures (continued)

EVERY

6 MONTHS

Maintenance

Oil blower motor

 

Figure 4 Blower motor

1.Remove the jacket top panel to access the blower motor.

2.Use only Anderol 465. DO NOT use household universal oils.

Use only Anderol 465 to lubricate the blower motor. Do not use common uni- versal household oils.

3.See Figure 4

4.Place a few drops of oil in each of the two oiler cups on the side of the blower motor.

Operate boiler relief valve

1.Before proceeding, verify that the relief valve outlet has been piped to a safe place of dis- charge, avoiding any possibility of scalding from hot water.

To avoid water damage or scalding due to valve operation, a metal discharge line must be connected to relief valve outlet and run to a safe place of disposal. This discharge line must be installed by a qualifed heating installer or service techni- cian in accordance with the instructions in the GV90+ Boiler Manual. The discharge line must be terminated so as to eliminate possibility of severe burns should the valve discharge.

2.Read the boiler pressure/temperature gauge to make sure the system is pressurized.

3.Lift the relief valve top lever slightly, allowing water to relieve through the valve and dis- charge piping.

4.If water flows freely, release the lever and allow the valve to seat. Watch the end of the relief valve discharge pipe to ensure that the valve does not weep after the line has had time to drain. If the valve weeps, lift the seat again to attempt to clean the valve seat. If the valve continues to weep afterwards, contact your qualified service technician to inspect the valve and system.

5.If water does not flow from the valve when you lift the lever completely, the valve or discharge line may be blocked. Immediately shutdown the boiler, following the lighting instructions on the inside jacket top. Call your qualified service technician to inspect the boiler and system.

END OF

SEASON

Maintenance

Follow boiler shutdown procedure

1.Follow “TO TURN OFF GAS TO APPLIANCE” on the Operating instruction on the inside of the jacket top panel.You will also find these instructions on page 12 of this manual.

2.Do not drain system unless exposure to freezing temperatures will occur.

3.Do not drain the system if it is filled with an antifreeze solution.

4.Do not shut down boilers used for domestic water heating. They must operate year-round.

Part number 550-142-055/0411

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents User’s Information Manual Read/use Please read this page firstHazard definitions STOP!! Read before proceedingAir contamination Combustion air contamination Prevent combustion air contaminationStart-up Perform maintenance per schedule belowCheck boiler pressure/temperature gauge User maintenance proceduresDaily Check boiler areaMonthly Check boiler interior pipingCheck venting system Clean vent termination & air intake screens Test low water cutoff if installedPeriodic Check condensate systemEvery Months Follow boiler shutdown procedureEND Season Oil blower motorIntegrated boiler control How it worksGV90+ Water Boiler Operating instructions Operating instructionsSymptom Common Causes Possible Corrections Common problems and solutionsPopping or percolating GV90+ gas-fired water boiler User’s Information Manual GV90+ gas-fired water boiler User’s Information Manual

GV90+ specifications

The Weil-McLain GV90+ is a high-efficiency gas boiler designed to meet the heating demands of residential spaces. Renowned for its reliability and superior performance, the GV90+ is ideal for home heating systems that require both efficiency and comfort.

One of the standout features of the GV90+ is its advanced condensing technology. This allows the boiler to recycle exhaust gases, extracting additional heat and maximizing energy usage. With an impressive Annual Fuel Utilization Efficiency (AFUE) rating of up to 90%, the GV90+ significantly reduces energy consumption, lowering heating bills while minimizing environmental impact.

The GV90+ also boasts a versatile design that can be integrated into a variety of heating systems. It is suitable for both hydronic heating applications and combination systems that provide domestic hot water. This adaptability makes it a popular choice for homeowners looking to enhance their existing heating setup or those building new homes.

Built with durability in mind, the GV90+ features a cast aluminum heat exchanger that is not only lightweight but also highly resistant to corrosion. This construction ensures longevity and reduces maintenance needs, thereby providing peace of mind for homeowners. The boiler's compact size further facilitates installation in tight spaces, making it a convenient solution for both new installations and replacements.

The GV90+ is equipped with an intuitive control system that simplifies operation. The integrated electronic ignition removes the need for a standing pilot, enhancing safety and improving reliability. This smart control technology also allows for precise temperature management, ensuring optimal comfort without unnecessary energy consumption.

Another highlight of the GV90+ is its whisper-quiet operation. Designed to minimize noise, this boiler allows homeowners to enjoy a warm and cozy environment without disruptive sounds. Additionally, Weil-McLain has incorporated safety features such as overheat protection and vent safety switches, ensuring the system operates safely within defined parameters.

In conclusion, the Weil-McLain GV90+ sets a high standard in the residential heating market with its exceptional efficiency, innovative technologies, and robust construction. Catering to a range of heating needs, it promises homeowners reliability, comfort, and significant energy savings, making it a wise investment for any home.
Top Page Image Contents