30 |
Transporting cleaner
To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels, and push forward.
31
The cleaner can also be moved by lifting it as shown.
32
A
Carpet height adjust- ment
The cleaning of carpet and rugs takes place at the nozzle (A).
33 |
If it is necessary to raise and lower the nozzle for various carpet pile heights, slide the nozzle control knob to the desired setting.
34 |
B |
C |
For ease in sliding knob, the handle should be in the upright position (B).
The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position (C).
35 | (A) |
| (B) | (4) |
(1) | (2) | (3) | ||
|
|
|
|
|
For maximum cleaning perfor- mance, the following carpet height settings are recommended.
Cleaners with Two Settings:
•Setting 1 (A):for bare floors and all carpet types.
•Setting 2 (B):if easier pushing effort is desired while maintaining good cleaning performance.
Cleaners with Four Settings:
•Lowest setting (1):for bare floors and low pile, level loop, kitchen type carpet.
•Next setting (2):for other types of carpet.
•Higher settings
Note: If the cleaner is difficult to push, slide knob to the next higher setting.
7