Step 2 Attach cord
3 | “UP” | G |
|
|
|
|
|
|
|
| |
D |
| C | F | E | B |
Note: The small red tab (E) above the ON/OFF switch (F) is for shipping purposes only and may fall off during assembly. If it does not fall off, the tab will be removed during the final steps of assembly.
Turn handle over. Insert large rectangular end of cord into pocket in bottom of handle, with side marked “UP” visible.
Make sure rectangular end is pushed into handle as far as possible.
Slide cord protector (G) toward upper handle (B).
4 | H | G |
|
Rotate cord protector (G) on cord until you see its arrow (H).
5 | I |
H | |
J | K |
|
With arrow on cord protector (H) pointing toward arrow on upper han- dle (I), press groove (J) in
cord protector into slot (K) in upper handle.
6 |
UP |
G |
Pull cord tight.
Press cord into place at each of the three notches indicated and note correct positioning of (G).
Do not plug cleaner in until assembly is totally complete.
Step 3 Attach cloth outer bag
7 |
|
| C |
M | L |
|
Note location of tapered rails (L) on back of outer bag base (M) and on front of lower handle (C).
8 |
|
M | N |
| |
| C |
Slide rails on outer bag (M) onto rails on lower handle (C) until outer bag base snaps past the lock tab
(N).
9 |
|
O |
|
N | M |
|
Make sure hole in outer bag base aligns with hole in handle (O).
Be sure that power cord is pulled tight and pressed into each of the three notches (Fig. 6) before com- pleting the following steps.
Continued ➜ | 3 |