Nilfisk-Advance America BR1100S manual 16 / English, After USE, Maintenance Schedule

Page 16

A-16 / ENGLISH

AFTER USE

1When finished scrubbing, press the Scrub Off Switch (E). This will automatically raise, retract and stop all the machine systems (brush, squeegee, vacuum, solution and detergent (EcoFlex models)). Then drive the machine to a service area for daily maintenance and review of other needed service up keep.

2To empty the solution tank, remove the Solution Drain Hose (4) from it’s storage clamp. Direct the hose to a designated “DISPOSAL SITE” and remove the plug. Rinse the tank with clean water.

3To empty the recovery tank, pull the Recovery Tank Drain Hose (19) from its storage area. Direct the hose to a designated “DISPOSAL SITE” and remove the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled flow of waste water). The Recovery Tank Drain Hose can be squeezed to regulate the flow. Rinse the recovery tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.

4Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.

5Remove the squeegee, rinse it with warm water and re-install on mount.

6Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by removing the skirt and tilting the hopper up and away from housing, then pull out.

7Check the maintenance schedule below and perform any required maintenance before storage

MAINTENANCE SCHEDULE

MAINTENANCE ITEM

Daily

Weekly

Monthly

Yearly

Charge Batteries

X

 

 

 

Check/Clean Tanks & Hoses

X

 

 

 

Check/Clean/Rotate the Brushes/Pads

X

 

 

 

Check/Clean the Squeegee

X

 

 

 

Check/Clean Vacuum Shut-Off Float

X

 

 

 

Check/Clean the vacuum motor foam filter(s)

X

 

 

 

Clean Hopper on Cylindrical System

X

 

 

 

Check Each Battery Cell(s) Water Level

 

X

 

 

Inspect Scrub Housing Skirts

 

X

 

 

Inspect and clean Solution Filter

 

X

 

 

Check Foot/ Parking Brake For Wear & Adjustment

 

X

 

 

Clean Solution Trough on Cylindrical System

 

X

 

 

Purge Detergent System (EcoFlex only)

 

X

 

 

Side Broom Maintenance

 

X

 

 

Lubrication - Grease Fittings

 

 

X

 

* Check Carbon Brushes

 

 

 

X

*Have Nilfisk check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every 500 hours or once a year.

NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.

8Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.

9Turn the Master Key Switch (A) OFF (O) and remove the key.

LUBRICATING THE MACHINE – FIGURE 9

Once a month, pump a small amount of grease into each grease fitting on the machine until grease seeps out around the bearings.

Grease fitting locations (or apply grease to) (AA):

•Squeegee Caster Wheel Axle and Pivot

•Steering Wheel Shaft Universal joint

•Steering Chain

•Squeegee mount angle adjustment knob threads

Once a month, apply light machine oil to lubricate the (BB):

•Squeegee tool end wheels

•Recovery Tank release latch

•Brake Pedal (parking brake) linkage

A-16- FORM NO. 56041978 - BR1100S / BR1300S

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Instructions for USE English Symbols English / A-3Know Your Machine English / A-5 Control Panel K3 K4 K9 K5When Servicing Batteries Install the BatteriesEnglish / A-7 Install the Brushes Disc System Install the Brushes Cylindrical System English / A-9Filling the Solution Tank 10 / EnglishSqueegee Installation English / A-11To Purge When Changing Chemicals 12 / EnglishDetergent System Preparation and USE Ecoflex Models only To Purge WeeklyEnglish / A-13 Purge14 / English Operating the MachineWET Vacuuming To ScrubEnglish / A-15 Maintenance Schedule 16 / EnglishAfter USE Lubricating the Machine FigureEnglish / A-17 18 / English Checking the Battery Water LevelCharging the Batteries Squeegee Adjustment Squeegee MaintenanceEnglish / A-19 Side Skirt Maintenance Side Skirt Height Adjustment20 / English To reverse or replace the scrub system side skirtsEnglish / A-21 Disk CylindricalSide Broom Maintenance 22 / EnglishProblem Possible Cause Remedy General Machine TroubleshootingEnglish / A-23 24 / English Revised 6/11Page Türkçe Önlemler VE Uyarilar Simgeler Türkçe / B-3Makinenizi Taniyin Türkçe / B-5 Kontrol Paneli Türkçe / B-7 ŞekilBataryalarin Takilmasi Bataryaların Bakım İşlemleriFirçalarin Takilmasi Disk Sistemi Türkçe / B-9 Firçalarin Takilmasi Silindir Sistemi10 / Türkçe Çözelti Deposunun DoldurulmasiTürkçe / B-11 Lastik Sileceğin Takilmasi12 / Türkçe Kimyasalların Değiştirilmesi Sırasında Tahliye içinHaftalık Tahliye için Deterjan YüzdesiTürkçe / B-13 TasfİyeMakinenin Çaliştirilmasi 14 / TürkçeOvma işlemi için Türkçe / B-15 Islak Vakumlama16 / Türkçe Kullanim SonrasiBakim Çizelgesi Makİnenİn YAĞLANMASI- ŞekİlTürkçe / B-17 Şekil Bataryalarin Şarj Edilmesi 18 / TürkçeBatarya SU Seviyesinin Kontrol Edilmesi Türkçe / B-19 Lastik Silecek BakimiLastik Silecek Ayari Lastik Silecek Açısının AyarlanmasıYAN Etekliğin Bakimi 20 / TürkçeYAN Eteklİk Yükseklİk Ayari Türkçe / B-21 Dİsk Sİlİndİr Şekil22 / Türkçe YAN Süpürgenİn BakimiTürkçe / B-23 Genel Sorun GİdermeSorun Olası Neden Çözüm Bkz. Servis el kitabı24 / Türkçe Teknİk Özellİkler ünite üzerinde monte ve test edilenNilfisk-Advance Incorporated Pas Nilfisk-Advance A/S

BR1100S specifications

The Nilfisk-Advance America BR1100S is a state-of-the-art, battery-powered floor scrubber that stands out for its exceptional performance, user-friendly design, and remarkable efficiency. Ideal for a variety of commercial applications, such as retail spaces, warehouses, and educational institutions, the BR1100S is engineered to provide unparalleled cleaning results while minimizing downtime.

One of the main features of the BR1100S is its compact design, which allows for easy maneuverability in tight spaces. With its slender profile, the scrubber can effortlessly navigate around obstacles, ensuring that no corner is left uncleaned. The machine is equipped with a scrub deck that features a width of 20 inches, making it suitable for medium-sized areas and ensuring quick coverage within stipulated cleaning times.

The BR1100S utilizes advanced lithium-ion battery technology, which provides up to 2.5 hours of continuous cleaning on a single charge. This ensures that cleaning tasks can be completed without interruptions, drastically enhancing productivity. The included charger allows for rapid recharging, further minimizing downtime.

Another key characteristic is the brush system, which employs a dual brush setup that enhances scrubbing efficiency. The scrubbing mechanism is designed to tackle tough dirt and grime while being gentle on the floor surface. Users have the option to select different brush pressure settings based on specific cleaning requirements, providing flexibility for various floor types.

Moreover, the BR1100S is equipped with automatic water control technology, allowing for optimal water usage. This smart system adjusts the water flow based on the cleaning speed, ensuring that floors are cleaned thoroughly without excess water wastage. Additionally, the machine features a simple and intuitive control panel, making it accessible for users of all experience levels.

Maintenance is also a breeze with the BR1100S. The removable recovery tank allows for easy disposal of used water, while the brushes can be changed with minimal effort. Coupled with a durable construction, this scrubber is designed to withstand heavy use, offering longevity and reliability.

In summary, the Nilfisk-Advance America BR1100S is a robust and efficient choice for floor cleaning. With its combination of innovative technology, user-friendly design, and impressive performance, it is a fantastic investment for businesses looking to maintain immaculate spaces.
Top Page Image Contents