Hands free hook

Remove every other screw as circled and save for later use.

Replace the 3 screws removed and tighten securely. Check motor for shipping stabilizers and remove if present.

Install rubber pad between fan body and canopy.

Remove the all thread studs from the lower part of the mounting bracket. Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #8.

Place canopy over fan body aligning holes.

Take 4 screws from hardware pack and insert 2 one on each side of bracket to match the L slot screw holes in canopy. Keep 2 screws for later use.

House

Black

White

Ground

Fan

Blue

Black

White

Green

Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to Safety Tips section of manual.

Place blade holders onto blades aligning holes in blade holder with holes in blade. Make sure that the side of the blade you select is facing downward. Install 3 screws and fiber wash- ers to back side of blade as shown. Tighten screws securely. Repeat this process 4 more times until all blades are assembled.

Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the equipment-grounding conductor on one side of the outlet box and ungrounded conductor on the other side of the outlet box.

Install blades to motor using the 10 motor screws provided. Tighten screws securely.

Lift fan to mounting bracket, aligning the “L” shape holes on the canopy with the screws on the mounting bracket. Turn the fan clockwise to lock in position. Re-install the screws removed in the previous step and tighten securely.

Install switch cap to fan using the 3 screws provided. Tighten securely.