Hisense Group KFR 28GWE, KFR 3201GWE, KFR 33GWE, KFR 2101GWE, KFR 25GWE Special Remarks

Page 17

Special Remarks

Heating ( ) Operation

Heating performance

Defrosting

POWER lamp

Because this air conditioner heats a room by drawing on the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low. If sufficient heat cannot be obtained with this air conditioner, use another heating appliance in conjunction with it.

When the outdoor temperature is low, frost or ice may from in the heat exchanger coil, reducing heating performance. When this happens, a microcomputer defrosting system will operate. At the same time the fan on the indoor unit stops ( or runs at very low speed in some cases). Heating operation restarts after several minutes. (This interval will vary slightly depending upon the outdoor temperature and the way in which frost forms).

For several minutes after the start of heating operation, the indoor fan will not start running until the indoor heat exchanger coil has warmed up sufficiently. This is because the COLD DRAFT PREVENTION SYSTEM is operating.

The POWER lamp also remains lit during defrosting or when the compressor has been turned off by the thermostat when the system is in the heating mode.

Power failure during operation

Clicking Sound

Clicking sound is heard from the air conditioner

In the event of power failure, the unit will stop. When the power is resumed, the unit will restart automatically after three minutes.

● In heating or cooling operation. Some plastic parts may expand of shrink due to a sudden temperature change. In this event, a clicking sound may occur. This is normal, and the sound will soon disappear.

The remote control unit sends the temperature signal to the air conditioner regularly

at three-minute intervals. If the signal from the remote control

unit stops for

more

than ten minutes due to the loss of the remote control unit or

other trouble,

the air

conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner’s position.

15

Image 17
Contents KFR 33GWE KFR 28GWE KFR 25GWE Compact Size Alert Symbols ContentsPage Composition of the Air Conditioner Power lamp Hipower lampTimer lamp ON/OFF buttonSymbols Timer ON/OFF button Transmitter HR. Timer button High Power buttonDisplay ON/OFF buttonTimer OFF button Timer on buttonTimer SET/CANCEL button Mode selector buttonOperation Guide HOW to Install BatteriesOperation with the Remote Control Unit Adjusting the Fan Speed Horizontal Adjusting the Airflow DirectionVertical Sweep functionNight Setback / Simultaneous Use Energy Saving Night Setback ModeSetting Procedure Using the 12-Hour on and OFF TimerSetting Procedures High Power Operation Using the 1-Hour OFF TimerCancellation procedure Cancellation proceduresSpecial Remarks Heating Operation Heating performance Defrosting Power lampOperation without the Remote Control Unit Care and CleaningCare and Cleaning Tips for Energy Saving TroubleshootingKFR-33GWE KFR-28GWE KFR-25GWE KFR-2101GWE KFR-3201GWE Schematic DiagramElectric Wiring Diagram Outdoor Packing List