Harman-Kardon AVR 354 RS-232 Serial Port, FM antenna uses a 75-ohm F-connector. See Figure

Page 22

CONNECTIONS

The FM antenna uses a 75-ohm F-connector. See Figure 13.

Figure 13 – FM Antenna

The AM loop antenna needs to be assembled. Connect the two leads to the spring terminals on the receiver. As AM antenna leads have no polarity, it doesn’t matter which of the two terminals is used for either lead. See Figure 14.

Figure 14 – AM Antenna

To enjoy XM satellite radio, purchase an XM antenna module designed for use with XM Ready devices and a subscription to the XM service. We recommend the XM Mini Tuner and Home Dock Bundle, available at www.xmradio.com. The older Connect and Play module is also com- patible with the AVR 354, but it may no longer be available in your area.

An XM Ready-compatible module uses the special connector on the AVR 354’s rear panel that allows you to use the AVR’s tuner, including its 40 preset station locations and remote control. Although you may use a module with standard audio connections, which may be indicated for “car and home use,” you will not be able to enjoy the AVR 354’s ease of control.

RS-232 Serial Port

The RS-232 serial port on the AVR 354 is used only for software upgrades. If we release an upgrade for the receiver’s operating system at some time in the future, it may be downloaded to the AVR using this port. Complete instructions will be provided at that time.

22

Image 22

Contents AVR Safety Information Important Safety InstructionsImportant Safety Information Do not place the unit directly on a carpeted surfaceStaple Invoice Here Table of Contents Harman Kardon AVR 354 7.1-Channel Audio/Video Receiver IntroductionThank you for choosing Harman Kardon Audio SectionAudio/Video Inputs Supplied AccessoriesAudio Inputs Digital Audio InputsVolume Knob Turn this knob to raise or lower the volume FRONT-PANEL ControlsDigital Video 4 Analog Indicator Input Indicators IR SensorResolution Video Source Navigation List Input Audio Inputs Optical 4 Standby/On Main PowerREAR-PANEL Connections Is not available in Alaska and HawaiiFM Antenna Bridge II 1, 2 Input Video Audio Outputs VideoComponent Video MonitorREAR-PANEL Connections Main Remote Control Functions Alphanumeric Keys Use these buttons to enter numbers for IR Transmitter Lens AVR Power Off Zone 2 Remote Control Functions Transport Controls Zone Indicator Typical Home Theater System Introduction to Home TheaterSurround Modes Multichannel AudioTypes of Connections Connecting Source Devices to the AVRConnections Speaker ConnectionsAudio Connections Digital AudioDigital Video AntennasVideo Connections Analog VideoFM antenna uses a 75-ohm F-connector. See Figure RS-232 Serial PortFront Speaker Placement Speaker PlacementPlacement of Surround Speakers in a 5.1-Channel System Placement of Surround Speakers in a 7.1-Channel SystemSubwoofer Placement Step Two Connect the Subwoofer InstallationStep One Connect the Speakers Step Three Connect the AntennasVideo Connections for non-HDMI sources Hdmi ConnectionsAudio Connections for non-HDMI sources Component video VideoConnect an Audio/Video Recorder PVD, DVR or TiVo Connect a CD Player or Any Audio-Only Device Connect a Tape Deck or Any Audio-Only RecorderConnect an iPod Using Docking Station Connecting a Game Console, Camera or Other DeviceStep Five Connect the Video Display Step Six Plug in AC Power Step Seven Insert Batteries in RemoteTurn on your source device Enter a code from , aboveStep Ten Install a Multizone System Optional Step Nine Remote IR Inputs and Output OptionalStep Eleven Turn On the AVR Press the Standby/On Switch on the front panel. See FigureAdvantage of using the Zone 2 Audio Outputs is the ability Two steps are required the first time you turn on the AVRAVR Power On and Source Selectors Using the On-Screen Menu System Initial SetupConfigure the AVR 354 Using EzSet/EQ Technology Selecting Cancel returns to the Speaker Setup menu Speaker Setup Menu ScreenSet Up Sources Audio and Video Input SelectionChannel Direct Inputs HDMI-Equipped Multichannel Disc PlayerAdjust Lip Sync You are now ready to begin enjoying your new receiverOperation Source Selection Using the TunerAVR defaults to automatic tuning, meaning each press If a video source is playing and there is no pictureRecording XM Radio OperationPress the Menu Button to view the slide-out menu Using Docking StationCharge the iPod IPod Manual Mode, the iPod menus will only be visibleUsing The Bridge Selecting a Surround Mode‹ / › Buttons Advanced Functions Analog Audio SignalsDigital Audio Signals Audio Processing and Surround SoundIndicates that no surround information is present Or 96kHz, and 5.1 or 7.1 multichannel PCMVirtual Surround Dolby Virtual Speaker Reference or Wide Dolby Surround Settings Night ModeStep Three Manual Setup Menu Manual SetupStep Two Measure Speaker Distances Sub Mode Adjust Crossover Frequencies MenuNumber of Speakers Adjust Speaker Distance Menu Step Four Setting Channel Output Levels ManuallyMake sure all speakers have been connected correctly Audio Effects Menu Sports For sporting events Video AdjustmentsNature For programs shot outdoors, in a natural setting Movie For movies and many television broadcastsContrast Adjustment How to Adjust the Custom Picture SettingsBrightness Adjustment Color AdjustmentMultizone Operation Installing a Multizone SystemOperating the Multizone System Menu Appearance System SettingsGeneral AVR Settings Menus and displays English, French, Spanish or GermanPunch-Through Programming Advanced Remote Control FunctionsResetting the Remote Activities MacrosProcessor Reset MemoryTroubleshooting Guide Appendix Appendix Default settings, worksheets, remote product codesTable A2 Source Setting Defaults Table A1 Recommended Source Component ConnectionsTable A3 Speaker/Channel Setting Defaults Table A4 Delay Setting DefaultsTable A6 Audio Effects Settings Table A5 Source SettingsTable A7 Video Modes Settings Table A10 System Settings Table A9 Remote Control CodesTable A8 Surround Modes Table A11 Zone 2 Settings Table A12 Surround ModesMovie Back channel 0 or .1, EX Analog 2-channel Tuner Mode Group Enveloping sound field is desiredExperience Tuner Music adds a surround back channel Analog 2-channel TunerPerformance Via Hdmi DTS-ES Matrix Surround Mode Description Incoming Bitstream or SignalRate used on DVD-Video discs DTS StereoChannels Tuner PCM 32kHz, 44.1kHz or 48kHz Channel Stereo Appropriate when a subwoofer is usedChannel Stereo Analog Bypass41 42 Radio Table A13 Remote Control Function ListDMC1000 Button Name Power OffTable A13 GameAiwa Table A15 Remote Control Product Codes AUX-HDTV Table A16 Remote Control Product Codes AUX-VCRTable A14 Table A17 Remote Control Product Codes AUX-CD Table A16Table A19 Remote Control Product Codes SAT Table A18 Remote Control Product Codes DVDTable A17 Table A23 Remote Control Product Codes Table A21 Remote Control Product Codes CBLTable A22 Remote Control Product Codes Table A24 Remote Control Product Codes AUX- TiVoAVR 354 Technical Specifications