INSTALLATION
a)Place the two remotes so that their IR transmitters face each other end to end, separated by about one inch. See Figure 39. The AVR 354 remote’s transmitter also serves as an IR receiver during the learning process.
Step Nine – Remote IR Inputs and Output (Optional)
The AVR 354 is equipped with a Remote IR Input, a Zone 2 Input and both
Figure 39 – AVR 354 and Original Remote Head-to-Head
b)Press the Source Selector for the device mode you wish to learn a code into, and place the AVR 354 remote in Learning mode by pressing and holding the Learn Button until the Source Selector lights up, then release. See Figure 40.
Figure 40 – Learning Remote Commands
c)Press the button on the AVR 350 remote you wish to program with the new code, and the Source Selector will flash once. You may learn a new code into the following buttons: Device Power On/Off, Alphanumeric Keys, Last Button, Back/Exit Button, Menu Button, ⁄/¤/‹ / › Navigation Buttons, OK Button, Disc Menu Button, the four Teletext Buttons, Channel Up/Down, Volume Up/Down, Mute and the Transport Controls (including Record).
d)Press and hold the button on the device’s original remote whose code you wish to “learn” until the Source Selector flashes three times, then release.
e)You may program additional buttons by repeating steps c) and d). Press the Learn Button once to exit Learning mode, or wait for the remote to “time out” and exit Learning mode on its own after about 30 seconds.
If you are unable to locate a code set that correctly operates your source device, it will not be possible to use the AVR remote to control that device. However, you may still connect the source to the AVR 354 and operate it using the device’s original remote control.
Most of the button labels on the remote describe the button’s function when used to control the AVR 354. However, the button may perform a very different function when used to control another device. Refer to the Remote Control Function List, Table A13 in the Appendix, for a list of each button’s functions with the various product types.
If you wish, you may program Activities, which are preprogrammed code sequences that execute many code commands with a single button press. You may also program
AVR 354
Figure 41 – IR Inputs and Outputs
When the AVR 354 is placed in such a way that aiming the remote at the
of the AVR 354 (and any sources connected to the AVR’s Remote IR Output) from the remote zone. Any signals transmitted through the Zone 2 IR Input will only control source selection and volume for the remote zone. If a source device is being shared with the main listening area, then any control commands issued to that source will also affect the main room.
If any of your source devices are equipped with a compatible Remote IR Input, use a 1/8"
Check with the manufacturer of the source device for more information on the type of IR signal expected. The AVR 354 will output a “stripped carrier” IR signal through the Remote IR Output, but a
To control more than one source device using the Remote IR Output, connect all sources in “daisy chain” fashion, with the AVR’s Remote IR Output connected to the first device’s Remote IR Input, the second device’s Remote IR Output connected to the next device’s Remote
IR Input, and so forth. Connect devices expecting a
Step Ten – Install a Multizone System (Optional)
The AVR 354 offers several methods of distributing music to other listening areas in your home. A multizone system is not required to enjoy the home theater experience. If you prefer not to install a multizone system at this time, skip to Step Eleven to turn on the AVR 354 and configure it.
32 | 32 |