Harman-Kardon owner manual AVR 354 Technical Specifications

Page 75

AVR 354 TECHNICAL SPECIFICATIONS

Audio Section

Stereo Mode

Continuous Average Power (FTC)

75 Watts per channel, 20Hz–20kHz,

@ <0.07% THD, both channels driven into 8 ohms

Seven-Channel Surround Modes

Power per Individual Channel

Front L & R channels:

75 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Center channel:

75 Watts @ <0.07% THD, 20Hz–20kHz into 8 ohms

Surround (L & R Side, L & R Back) channels: 75 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Input Sensitivity/Impedance

 

Linear (High-Level)

200mV/47k ohms

Signal-to-Noise Ratio (IHF-A)

100dB

Surround System Adjacent Channel Separation

Pro Logic® I/II

40dB

Dolby® Digital (AC-3)

55dB

DTS®

55dB

Frequency Response

 

@ 1W (+0dB, –3dB)

10Hz – 130kHz

High Instantaneous

 

Current Capability (HCC)

±35 Amps

Transient Intermodulation

 

Distortion (TIM)

Unmeasurable

Slew Rate

40V/µsec

FM Tuner Section

 

Frequency Range

87.5 –108.0MHz

Usable Sensitivity

IHF 1.3µV/13.2dBf

Signal-to-Noise Ratio

Mono/Stereo 70/68dB

Distortion

Mono/Stereo 0.2/0.3%

Stereo Separation

40dB @ 1kHz

Selectivity

±400kHz, 70dB

Image Rejection

80dB

IF Rejection

90dB

AM Tuner Section

 

 

Frequency Range

520–1720kHz

 

Signal-to-Noise Ratio

45dB

 

Usable Sensitivity

Loop 500µV

 

Distortion

1kHz, 50% Mod 0.8%

 

Selectivity

±10kHz, 30dB

 

Video Section

 

 

Television Format

NTSC

 

Input Level/Impedance

1Vp-p/75 ohms

 

Output Level/Impedance

1Vp-p/75 ohms

 

Video Frequency Response

 

 

(Composite and S-Video)

10Hz–8MHz (–3dB)

 

Video Frequency Response

 

 

(Component Video)

10Hz–100MHz (–3dB)

 

HDMI™

Version 1.3a with 10-bit Deep Color

General

 

 

Power Requirement

AC 120V/60Hz

 

Power Consumption

118W idle, 890W maximum

 

 

(7 channels driven)

 

Dimensions

(Product)

(Shipping)

Width

17-5/16 inches (440mm)

21-7/8 inches (555mm)

Height

6-1/2 inches (165mm)

10-1/2 inches (266mm)

Depth

15 inches (382mm)

18-5/16 inches (465mm)

 

(Product)

(Shipping)

Weight

31.5 lb (14.3kg)

36.7 lb (16.7kg)

Depth measurement includes knobs, buttons and terminal connections.

Height measurement includes feet and chassis.

All features and specifications are subject to change without notice.

Harman Kardon and Logic 7 are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. EzSet/EQ, Designed to Entertain and The Bridge II logo are trademarks of Harman International Industries, Incorporated.

iPod, iTunes and Apple are trademarks of Apple Inc., registered in the U.S. and other countries. “Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

Audiovox is a registered trademark of Audiovox Corporation.

Blu-ray Disc is a trademark of the Blu-ray Disc Association.

CEA is a registered trademark of the Consumer Electronics Association.

Cirrus Logic is a registered trademark of Cirrus Logic, Inc.

Dolby and Pro Logic are registered trademarks, and MLP Lossless is a trademark, of Dolby Laboratories.

DTS, DTS-ES and DTS Neo:6 are registered trademarks, and DTS 96/24, DTS-HD and DTS-HD Master Audio are trademarks, of DTS, Inc.

Faroudja DCDi Cinema is a trademark of Genesis Microchip Inc.

HD-DVD is a trademark of the DVD Format/Logo Licensing Corporation (DVD FLLC).

HDMI is a trademark or registered trademark of HDMI Licensing LLC.

SACD is a trademark of Sony Corporation.

TiVo is a registered trademark of TiVo Inc.

XM and XM Ready are registered trademarks of XM Satellite Radio.

Please register your AVR 354 at www.harmankardon.com.

NOTE: You’ll need the product’s serial number. At the same time, you can choose to be notified about new products and/or special promotions.

75

Page 74 Page 76
Image 75
Page 74 Page 76
Contents AVR Important Safety Instructions Safety InformationDo not place the unit directly on a carpeted surface Important Safety InformationStaple Invoice Here Table of Contents Audio Section IntroductionThank you for choosing Harman Kardon Harman Kardon AVR 354 7.1-Channel Audio/Video ReceiverDigital Audio Inputs Supplied AccessoriesAudio Inputs Audio/Video InputsFRONT-PANEL Controls Volume Knob Turn this knob to raise or lower the volumeList Input Audio Inputs Optical 4 Standby/On Main Power Input Indicators IR SensorResolution Video Source Navigation Digital Video 4 Analog IndicatorIs not available in Alaska and Hawaii REAR-PANEL ConnectionsVideo Monitor Audio Outputs VideoComponent FM Antenna Bridge II 1, 2 Input VideoREAR-PANEL Connections Main Remote Control Functions Alphanumeric Keys Use these buttons to enter numbers for IR Transmitter Lens AVR Power Off Zone 2 Remote Control Functions Transport Controls Zone Indicator Multichannel Audio Introduction to Home TheaterSurround Modes Typical Home Theater SystemSpeaker Connections Connecting Source Devices to the AVRConnections Types of ConnectionsDigital Audio Audio ConnectionsAnalog Video AntennasVideo Connections Digital VideoRS-232 Serial Port FM antenna uses a 75-ohm F-connector. See FigurePlacement of Surround Speakers in a 7.1-Channel System Speaker PlacementPlacement of Surround Speakers in a 5.1-Channel System Front Speaker PlacementSubwoofer Placement Step Three Connect the Antennas InstallationStep One Connect the Speakers Step Two Connect the SubwooferComponent video Video Hdmi ConnectionsAudio Connections for non-HDMI sources Video Connections for non-HDMI sourcesConnect an Audio/Video Recorder PVD, DVR or TiVo Connect a Tape Deck or Any Audio-Only Recorder Connect a CD Player or Any Audio-Only DeviceConnecting a Game Console, Camera or Other Device Connect an iPod Using Docking StationStep Five Connect the Video Display Step Seven Insert Batteries in Remote Step Six Plug in AC PowerEnter a code from , above Turn on your source deviceStep Nine Remote IR Inputs and Output Optional Step Ten Install a Multizone System OptionalTwo steps are required the first time you turn on the AVR Press the Standby/On Switch on the front panel. See FigureAdvantage of using the Zone 2 Audio Outputs is the ability Step Eleven Turn On the AVRAVR Power On and Source Selectors Initial Setup Using the On-Screen Menu SystemConfigure the AVR 354 Using EzSet/EQ Technology Speaker Setup Menu Screen Selecting Cancel returns to the Speaker Setup menuAudio and Video Input Selection Set Up SourcesHDMI-Equipped Multichannel Disc Player Channel Direct InputsYou are now ready to begin enjoying your new receiver Adjust Lip SyncOperation If a video source is playing and there is no picture Using the TunerAVR defaults to automatic tuning, meaning each press Source SelectionXM Radio Operation RecordingIPod Manual Mode, the iPod menus will only be visible Using Docking StationCharge the iPod Press the Menu Button to view the slide-out menuSelecting a Surround Mode Using The Bridge‹ / › Buttons Audio Processing and Surround Sound Analog Audio SignalsDigital Audio Signals Advanced FunctionsOr 96kHz, and 5.1 or 7.1 multichannel PCM Indicates that no surround information is presentVirtual Surround Dolby Virtual Speaker Reference or Wide Night Mode Dolby Surround SettingsManual Setup Step Three Manual Setup MenuStep Two Measure Speaker Distances Adjust Crossover Frequencies Menu Sub ModeNumber of Speakers Step Four Setting Channel Output Levels Manually Adjust Speaker Distance MenuMake sure all speakers have been connected correctly Audio Effects Menu Movie For movies and many television broadcasts Video AdjustmentsNature For programs shot outdoors, in a natural setting Sports For sporting eventsColor Adjustment How to Adjust the Custom Picture SettingsBrightness Adjustment Contrast AdjustmentInstalling a Multizone System Multizone OperationOperating the Multizone System Menus and displays English, French, Spanish or German System SettingsGeneral AVR Settings Menu AppearanceActivities Macros Advanced Remote Control FunctionsResetting the Remote Punch-Through ProgrammingMemory Processor ResetTroubleshooting Guide Table A1 Recommended Source Component Connections Appendix Default settings, worksheets, remote product codesTable A2 Source Setting Defaults AppendixTable A4 Delay Setting Defaults Table A3 Speaker/Channel Setting DefaultsTable A5 Source Settings Table A6 Audio Effects SettingsTable A7 Video Modes Settings Table A9 Remote Control Codes Table A10 System SettingsTable A8 Surround Modes Table A12 Surround Modes Table A11 Zone 2 SettingsMusic adds a surround back channel Analog 2-channel Tuner Mode Group Enveloping sound field is desiredExperience Tuner Movie Back channel 0 or .1, EX Analog 2-channel TunerDTS Stereo Surround Mode Description Incoming Bitstream or SignalRate used on DVD-Video discs Performance Via Hdmi DTS-ES MatrixAnalog Bypass Appropriate when a subwoofer is usedChannel Stereo Channels Tuner PCM 32kHz, 44.1kHz or 48kHz Channel Stereo41 42 Table A13 Remote Control Function List RadioDMC1000 Game Power OffTable A13 Button NameAiwa Table A16 Remote Control Product Codes AUX-VCR Table A15 Remote Control Product Codes AUX-HDTVTable A14 Table A16 Table A17 Remote Control Product Codes AUX-CDTable A18 Remote Control Product Codes DVD Table A19 Remote Control Product Codes SATTable A17 Table A24 Remote Control Product Codes AUX- TiVo Table A21 Remote Control Product Codes CBLTable A22 Remote Control Product Codes Table A23 Remote Control Product CodesAVR 354 Technical Specifications
Top Page Image Contents