Safety Instructions, Safety instructions

Safety Instructions

Safety instructions

NOTE: In the event of leaks in the water pipework close the main cold water stop valve. This is often located under a kitchen sink.

IMPORTANT: A thermostatic mixing valve must be fitted to the outlet of the cylinder and can be adjusted to the desired domestic hot water temperature by an installation or service engineer. Otherwise there is a risk of scalding as the cylinder outlet temperature at the taps could be up to 85°C.

IMPORTANT: Risk of damage! Do not remove or modify any components of the solar cylinder.

In the unlikely event of a malfunction occurring of the Flurocyl, such as hot water flowing out of the temperature and pressure relief valve, switch off the boiler and the immersion heater and contact Glow-worm or your installer.

Frost protection of the twin coil solar cylinder

You must drain the solar cylinder completely if it is to be shut down in a room prone to frost. It is drained at the cold water inlet with a T-piece with tap to be provided by the installer.

Also drain all heat exchangers which are not filled with solar fluid.

1 Product Specifications

	Unit	Flurocyl 200 l	Flurocyl 250 l	Flurocyl 300 l
Cylinder:
Size	l	200	250	300
Maximum water supply pressure	bar		10
Operating pressure	bar		3.5
Pressure limiting valve	bar		3.5
Expansion relief valve	bar		6.0
Hot water expansion vessel admission pressure	bar		4.0
Temperature and pressure relief valve	°C/bar		95 / 7.0
Net weight	kg	39	44	49
Weight (full)	kg	245	310	340
Height	mm	1499	1789	2109
Cylinder connections:
Cold water supply		22 mm pressure pipe
Hot water connection		22 mm pressure pipe
Pressure-controlled cold water outlet		22 mm pressure pipe
Secondary return	Inches	G 3/4
Flow (boiler/solar circuit)		22 mm pressure pipe
Return (boiler/solar circuit)		22 mm pressure pipe
Electrical connections:
3 kW immersion heater (according to ENBS 60335)		230/240 V, 50 Hz
Length of the immersion heater	mm	430
Motorised 2 port valve		230/240 V, 50 Hz
Cylinder thermostat		230/240 V, 50 Hz
Thermal cut out for solar pump		230/240 V, 50 Hz
Heating coil:
Heat loss	kW/24 h	1.9	2.1	2.4
Heat up time (boiler part)	mins	21	26	30
Recovery (boiler part)	mins	13	16	21

Table 1.1 Technical data